User manual NUMARK RM6

[. . . ] When removing the cord from a power outlet be sure to remove it by holding the plug attachment and not by pulling on the cord. Object and Liquid Entry - Take care that objects do not fall into and that liquids are not spilled into the inside of the mixer. Cleaning ­ The appliance should be cleaned only as recommended by the manufacturer. Non-use Periods ­ The power cord of the appliance should be unplugged from the outlet when left unused for long periods of time. [. . . ] This is ideal for connecting an XLR gooseneck directly into the mixer. Panning ­ controls the mix of stereo audio available from the channel. When moved to the left only the left speakers will be heard, or to the right for the right speakers. 2. Stereo Level Indicator- quickly and accurately tracks level of audio output. When using as a master output meter, set the crossover, equalizer and power amp inputs to avoid distortion at each step in the audio chain. Proper attention to the peak meter results in the punchiest possible sound without audible distortion. Zone EQ ­ adjusts the Treble, Middle, and Bass frequencies respectively of the zone audio. Headphone Jack ­ for plugging in your headphones. Rear Panel Features 14 15 16 22 17 18 19 20 21 23 24 25 26 28 27 14. Power Supply Input - to plug your power adapter in before switching on power. Balanced Zone 2 Outputs - are 1/4" Stereo Balanced TRS 1/4" connectors controlled by the Zone 2 fader knob. Power transformers and other devices that cause magnetic fields can induce hum in audio cables. This can be best resolved by using balanced lines where inputs and outputs permit. Balanced lines are also the most effective means of reducing or eliminating RF or radio frequency" interference. Balanced Zone 1 Outputs - are Balanced Stereo XLR connectors controlled by the Zone 1 fader knob. Master Gain Reduction ­ to set optimal output level of the balanced outputs to be set at . 245V to 2. 5V to match the optimal inputs of amplifiers and other devices. Unbalanced Zone Outputs ­output controlled by the Zone fader knobs. Unbalanced Line Inputs - to connect stereo audio from HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners, even synthesizers or other mixing consoles. Note: Plug mono audio sources into both Left and Right inputs using a "Y" cable connector. Note: Line 3 can receive a turntable input depending phono/line switch position. Phono/Line switch ­ select the appropriate position for your input device. With phono selected the input signal is fed directly to the high-quality RIAA phono pre-amplifiers so use this input only for turntables. Switch this over to the Line position for line devices such as CD players and Tape decks. Ground lug - use these connections with your turntables' grounding cable to avoid signal hum. [. . . ] Accordingly, additional statements such as dealer advertising or presentation, whether oral or written, do not constitute warranties by NUMARK and should not be relied upon. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES OR HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO PURCHASER. You may also have other rights, which vary from one jurisdiction to another. RETURN INFORMATION a) b) c) d) e) f) g) A Return Authorization number must be obtained from Numark through the address or phone numbers below. A copy of the original sales receipt must also be included for the equipment to be repaired under warranty. [. . . ]