User manual NUMARK PPD01

[. . . ] USER'S MANUAL ©2002 Industries http://www. numark. com PPD01 SAFETY INSTRUCTIONS a) b) c) d) e) f) Read Instructions - All the safety and operating instructions should be read before this product is connected and used. Retain Instructions - The safety and operating instructions should be kept for future reference. Heed Warnings - All warnings on this product and in these operating instructions should be followed. Follow Instructions - All operating and other instructions should be followed. [. . . ] a) b) When PROGRAM is indicated, this meter displays the stereo output levels of your mixed signal. When CH1 CH2 is indicated the meter shows the peak, "PFL", Pre Fader levels of channels 1 and 2. You can use the channel "Gain" and "EQ" controls to match the levels of input signals while cueing 13. "Cue Gain Knob" (Headphone Level): This rotary control adjusts the levels of the headphones connected to the front panel input. "Cue Tone Knob" (Headphone Tone Control): This rotary knob adjusts the tone of the headphone output. "Channel Cue Slider": Channels 1 and 2 can be previewed using this mini-crossfader. Sliding this to the left plays the left channel-1 and sliding to the right plays the right channel-2. "Cue Button" (MIC and MASTER Cue Buttons): When pressed, the CUE button illuminates green indicating that the source is being cued to the headphones. "Headphone Jack" (Quarter Inch Output Terminal): Your headphones can be connected to this ¼" terminals. The Volume should always be set at its lowest setting while connecting and disconnecting headphones to prevent damage to headphones and/or your hearing. "Crossfader Slider" (Digital VCA Crossfader): This slide fader blends audio between CH-1 and CH-2. Its action can be modified with the "Mode" , "Slope", and "Direction" controls. This digital mixer uses digital VCA technology to accurately determine slider position. Both the VCA and Digital technologies combined allow for some very powerful effects. Simply remove the facepanel and then remove the screws holding it in position. Replace the fader with a quality authorized replacement from your local Numark retailer. "MODE and MODE Display" (Crossfader Function Control and Display): This toggle switch changes crossfader modes be left-right movement. The current mode is indicated in the mode display under the crossfader. These modes are described in detail in the section entitled "CROSSFADER MODES". "Contour Knob" (Crossfader Rate/Slope Control): The position of this switch determines how quickly or intensely the crossfader will act depending upon mode setting. "Direction Button" (Crossfader Reverse Control): Activation of this switch reverses the assignment of CH-1 and CH-2 on the crossfader. Output Controls 22. "Master Knob" (Main Output Level Control): This rotary control adjusts the main output volume. [. . . ] Purchaser must then return the mixer to NUMARK in an adequate container for shipping, accompanied by purchaser's sales receipt or comparable proof of sale showing the date of purchase, the serial number of the product, and the seller's name and address. To obtain an RA# and assistance on where to return the mixer, contact NUMARK customer service at 401-295 9000. NUMARK may, at NUMARK'S sole discretion, use rebuilt, reconditioned, or new parts or components when repairing any product or replace a product with a rebuilt, reconditioned or new product. Repaired mixers will be warranted for a period equal to the remainder of the original Limited Warranty on the original mixer or for (90) days, whichever is longer. [. . . ]