User manual NUMARK DM1885X

[. . . ] Professional Disc Jockey Products DM 1885X STEREO MIXER OWNER'S MANUAL NUMARK INDUSTRIES 11 Helmsman Road, North Kingstown RI 02852 http://www. numark. com DM1885X Numark - The Proven Leader in DJ Technology ©1997 Numark Industries 2 http://www. numark. com DM1885X CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE ANY COVER. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying this appliance. 6. Heat - Avoid placing this product too close to any high heat sources such as radiators. [. . . ] 11. The replaceable Crossfader achieves clean segues between two selected input channels. The Zone Levels control speaker volume for other outputs such as control booth monitors, a tape deck, another amplifier, a sub-woofer, another mixer or a satellite speaker system. In this example, Channel 1 is selected on the Left and Channel 3 is selected on the Right. Use the Crossfader for fast and seamless segues from one channel to the next. The Stereo/Mono Toggle Switches allow you to select N o t e : the crossfader is user replaceable. Simply unscrew the two large screws which hold it in place, lift it out, and disconnect its cable. Reattach the new crossfader and screw it back onto the unit - you're back in business!REPLACEMENT CROSSFADERS can be purchased from your local Numark Dealer, or by calling Numark Industries. 12. The Cue Crossfader controls what signal is being monitored through your headphones. Move the slide control to the left and you will hear your source music from the channel(s) selected with the cue/PFL switch. The same digital signal processing components used in professional audio equipment deliver CD-quality samples. The accompanying LEDs illuminate to show you which specific mode you are in at any time. Modes are: · R e p e a t sets the unit to play back a sample and automatically repeat (loop) when it gets to the end of the sample. aTO RECORD A SAMPLE Press the Write button once to go into stand by mode. b - Select the bank (or multiple banks) into which you want to record. If you want to record a longer sample select multiple banks (they must be adjoining). To playback a multi-bank sample you must reselect the same banks later. Note: To overwrite an existing sample, select that bank instead of an empty bank. Changing bank selection at this point in time is possible and will not destroy any previously recorded samples. fHit Start-Stop a second time to stop the sampling, or allow the memory banks to fill up, at which time sampling will stop automatically. Once your writing is complete the sampler will automatically switch to Single playback mode and light the Single LED. The sampler is now ready for playback. · Edit sets the unit to sample edit. [. . . ] Line level sources will overload the sensitive phono preamps and will sound very bad, so always be sure to 4. The Stereo Zone Outputs are low-impedance toggle the line/phono switch over to line before unbalanced RCA jacks controlled by the Zone Level connection of line sources. The S e n d can be attached to an external effects treatment of the power cord. GND is the grounding lug for turntables 1, 2 and 3 The Line Input is selected with the toggle switch on the (phono inputs on Channels 1, 2 and 3). [. . . ]