User manual NUMARK CM1000

[. . . ] Professional Disc Jockey Products CM1000 CM1000R PROFESSIONAL CLUB MIXER Owner's Manual CM1000/CM1000R ©2000 Industries http://www. numark. com - The Leader in DJ Technology ©2000 Industries -2http://www. numark. com CM1000 Safety Information i) j) k) l) m) n) o) SAFETY INSTRUCTIONS a) b) c) d) e) Read Instructions - All the safety and operating instructions should be read before this product is connected and used. Retain Instructions - The safety and operating instructions should be kept for future reference. Heed Warnings - All warnings on this product and in these operating instructions should be followed. Follow Instructions - All operating and other instructions should be followed. [. . . ] Can also be used as an additional zone or lighting control Booth source switch ­ routes either program audio or cue selected audio to the booth output. In "CUE" mode the output audio matches selections made for the headphones. For instance, in split cue mode you would here cued audio in the left booth speaker and program audio in the right booth speaker. In this way mixing can be done without headphones. - The Leader in DJ Technology ©2000 Industries -8http://www. numark. com CM1000/CM1000R CROSSFADER 16. Replaceable Crossfader - achieves clean segues between the two input channels selected by the Crossfader Assign. OUTPUTS 4-Band EQ control ­ adjusts the master output according the setting on the rear panel. When the unit is set for +/- 6 or 12dB the unit will increase or decrease the frequency area adjusted. Stereo/Mono toggle - adjusts the Master output for stereo or mono operation. Stereo Auto Peak Hold Level Indicator- quickly and accurately tracks level of audio sent to it by the meter assign. The red LEDs for +3dB, +5dB and +8dB hold program peaks for a second or two. With peak metering, it's OK to be "in the red" as long as +5dB or +8dB aren't constantly lit. When using as a master output meter, set the crossover, equalizer and power amp inputs to avoid distortion at each step in the audio chain. Proper attention to the peak meter results in the punchiest possible sound without audible distortion. When used to adjust the PFL levels, accurately match channel levels with the Pre-fader gain controls before mixing them together. The idea is to properly match PFL inputs, not the input with the stereo output meter!Zone Faders - controls speaker volume for a remote zone or booth monitors. NOTE: This can also be used to supply line level audio to a lighting controller or to lights that are sound activated. 21. In this example "Hard left" selects Channel 1 and "Hard right" selects Channel 4. Use the crossfader for fast and seamless segues from one selected channel to the other. Simply remove all knobs from the facepanel and unscrew the 5 screws that hold it in place. Then remove the 2 fader screws that hold the crossfader to the subchassis, lift it out and disconnect its cable. Re-attach the new crossfader and replace the faceplate and knobs back onto the unit - you're back in business! [. . . ] During the applicable warranty period, NUMARK will repair or replace, at NUMARK'S sole discretion, without charge to the purchaser, any defective component part of the mixer. To obtain service under this Limited Warranty, purchaser must first contact NUMARK and obtain a return authorization number ("RA#"). Purchaser must then return the mixer to NUMARK in an adequate container for shipping, accompanied by purchaser's sales receipt or comparable proof of sale showing the date of purchase, the serial number of the product, and the seller's name and address. To obtain an RA# and assistance on where to return the mixer, contact NUMARK customer service at 401-295 9000. [. . . ]