User manual NUMARK CM100

[. . . ] j) Object and Liquid Entry - Take care that objects do not fall into and that liquids are not spilled into the inside of the mixer. k) Cleaning ­ The appliance should be cleaned only as recommended by the manufacturer. l) Non-use Periods ­ The power cord of the appliance should be unplugged from the outlet when left unused for long periods of time. m) Damage Requiring Service Only qualified personnel should service this product. [. . . ] For best results, use a dynamic cardioid microphone. NeutrikTM "Combo" connector - allows connection of either a 1/4" jack or an XLR jack. This is ideal for connecting an XLR gooseneck directly into the mixer. CROSSFADER 3. Crossfader Assign Knob - determines which input channel will be heard when the crossfader is moved towards the knob. Replaceable Crossfader - achieves clean segues between the two input channels selected by the Crossfader Assign. 9. 4. 5. 6. 7. In this example "Hard left" selects Channel 1 and "Hard right" selects Channel 4. Use the crossfader for fast and seamless segues from one selected channel to the other. Simply unscrew the two large screws that hold it in place, lift it out and disconnect its cable. Re-attach the new crossfader and screw the mounting plate back onto the unit - you're back in business!Fader Start ­ activates the crossfader to send play and cue commands to your auto-start Numark CD player or other popular brand. For fader start, attach your mixer to a remote start CD player using industry standard 1/8"(3. 5mm) cables. When you move the crossfader toward the active channel, the attached CD player will start. When it is moved away, that side will cue (similar to pressing the cue button). - The Leader in DJ Technology ©1999 Industries -8http://www. numark. com CM100 EQUALIZER 12. 5-Band Stereo Graphic Equalizer (EQ) compensates for differences in source material sound quality. In ultra-compact mobile systems this EQ can be used to tailor the sound to the acoustical requirements of the room. Faders have a center detent for an accurate "flat" response. Start with this setting if you've never used a graphic EQ before: OUTPUTS 14. Stereo/Mono toggle - adjusts the Master output for stereo or mono operation. Booth/Zone Fader - controls speaker volume for a remote zone or booth monitors. NOTE: This can also be used to supply line level audio to a lighting controller or to lights that are sound activated. Below is an example of a poor EQ curve because it cuts the output volume down by 6-12dB. Meter Assign ­ determines whether pre-fader or master audio is sent to the stereo LED meter. Stereo Auto Peak Hold Level Indicator- quickly and accurately tracks level of audio sent to it by the meter assign. The red LEDs for +3dB, +5dB and +8dB hold program peaks for a second or two. With peak metering, it's OK to be "in the red" as long as +5dB or +8dB aren't constantly lit. When using as a master output meter, set the crossover, equalizer and power amp inputs to avoid distortion at each step in the audio chain. [. . . ] Accordingly, additional statements such as dealer advertising or presentation, whether oral or written, do not constitute warranties by NUMARK and should not be relied upon. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES OR HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO PURCHASER. You may also have other rights, which vary from one jurisdiction to another. RETURN INFORMATION a) b) c) d) e) f) g) A Return Authorization number must be obtained from Numark through the address or phone numbers below. A copy of the original sales receipt must also be included for the equipment to be repaired under warranty. [. . . ]