User manual NOVAK SMART-STOP LI-PO CUT-OFF MODULE

[. . . ] SMART-STOP Li-Po Battery Cut-Off Circuit ·read completely before installation or set-up· The Smart-Stop monitors the Li-Po's voltage & safely cuts off the ESC's throttle output when the voltage drops below a safe level--6. 25V for 2-Cell Smart-Stop (#5470), 9. 375V for 3-Cell (#5472), & 12. 5V for 4-Cell (#5471). Mounting Position--The Smart-Stop is best positioned near the ESC, as its main power leads (20G Red & Black silicone wires) connect easiest to ESC's battery power wire tabs (if ESC has solder tabs)--Smart-Stop can also connect to battery, battery connector, or battery's power wires. Based on where your Smart-Stop will connect, select a position where the unit can be mounted in the vehicle (do not mount at this time). [. . . ] Connect Smart-Stop's harness to receiver throttle channel (#2), making sure wiring sequence matches the other receiver connections. Very old radio systems may require changing the wiring sequence in plug. Smart-Stop Programming--Sets transmitter's neutral point into Smart-Stop. ESC should already be set-up & programmed to your transmitter (One-Touch on Novak ESCs). With a charged battery pack in vehicle & transmitter turned ON: Press & Hold the Smart-Stop's push button (under heat shrink) then turn on ESCs power switch-continue holding button until the Red LED comes on solid, then release button. Go to Full-Throttle position with transmitter & hold until the Green LED comes on solid, then return to Neutral. The Green LED will flash, then the Red LED will come back on, indicating that the Smart-Stop is programmed & ready. Mount Smart-Stop--Use the included double-sided tape or a tie-wrap to mount the Smart-Stop in vehicle. Mount label-side down if you want access to the push button & LEDs. Blue Indicator LED--Included with the Smart-Stop is a high-power Blue LED that can be mounted in the vehicle where it's easy to see while running--antenna tube, shock tower, wing mount, or ream a hole in the body so it `pops' in from underneath. [. . . ] In no case shall our liability exceed the product's original cost. Warranty does not cover water damage, use with incorrect number of cells, incorrect installation, short-circuiting, or any damage to other electronics used in conjunction with the Smart-Stop. [. . . ]