User manual NOVAK BRAKE LIGHT KIT

[. . . ] Accessory Kit #5655 For ESCs with built-in Brake Light Circuitry TO CONNECT BRAKE LIGHTS: 1. [. . . ] This will seal the connection and protect the ESC from a short that may occur if wires are left exposed. Insert the LED into the red mounting bracket so that the two metal leads pass through and exit the two small holes on the bottom of the bracket. Note: The metal lead on the flat side of the LED is the positive lead. Connect the LED to the JST connector by inserting the metal lead on the flat side of the LED to the "RED" slot (positive) and the other lead to the "BLK" slot (negative). Note: Plugging the LED in backwards will not cause damage but the LED will not work. MOUNTING THE BRAKE LIGHT BRACKETS: The brake light brackets can be mounted behind the tail light section of the car body or onto most any vertical or horizontal surface on the chassis or body. · To mount the brake light brackets to the tail light section, insert the screws through holes in the car body and into the screw openings in the brake light bracket. · To mount the brake light brackets to the chassis use double-sided mounting tape, an existing screw hole, or drill two holes at proper spacing and use the enclosed screws. The Novak Brake Light Kit includes two high luminescent LEDs and brake light mounting brackets that can be mounted to almost any vertical or horizontal chassis surface. [. . . ] If the speed control's Reverse Disable function has been activated for forward-only operation of the vehicle, the lights will not operate. Step 3 & 4 Twist or solder the two small ESC brake light wires to the wires on the JST harness, and seal connection with heat shrink tubing. ESC Step 5 & 6 Insert LED into red mounting bracket and connect the LED's metal leads to the JST connector harness. BRAKE LIGHT SET-UP PHOTO CAR BODY (Inside) ©1999 Novak Electronics, Inc. [. . . ]