User manual NISSAN PATHFINDER LE SPECIFICATION DATA

[. . . ] All information, specifications and illustrations in this manual are those in effect at the time of printing. NISSAN reserves the right to change specifications or design at any time without notice. Table of Contents Introduction How does the Nissan navigation system work?Information on map data discs Troubleshooting guide Index 1 2 3 4 5 6 7 8 9 10 11 12 13 14 1 Introduction How to use this manual . 1-3 HOW TO USE THIS MANUAL This manual uses special words and icons, organized by function. [. . . ] Select the key or key on the [EDIT ROUTE] screen. 5-32 How do I program a destination? It is also possible to set a waypoint by selecting the Waypoint key in the [DEST. SETTING] screen. Setting the priorities for route calculation After the setting of destinations and waypoints is completed, set the calculation conditions such as route type with high priorities. INV2343 INV1857 The [EDIT ROUTE] screen will be displayed. Select a waypoint destination using one of the destination selection procedures outlined earlier in the chapter. Select the conditions with high priorities. If you want to get to your destination in the shortest time, select the Shortest Time key. Selecting the key will turn the indicator light in the key ON; selecting it again will turn it OFF. INFO: When you select the OK key at this point, route calculation will start without any additional waypoints. Press the PREV button to display the [EDIT ROUTE] screen. How do I program a destination?5-33 Shortest Distance key: The route to the destination is calculated so that it is the shortest distance. Minimize Toll Road key: The route to the destination is calculated with minimum use of toll roads. INFO: When the ROUTE button is pressed on the map and the Edit Route key is selected, the [EDIT ROUTE] screen will be displayed. 2. Select each key on the screen to turn its respective indicator light ON or OFF. When the vehicle arrives at the neighborhood of the destination, the route guidance will end automatically. INFO: To alternate between the map and the enlarged screen, press the MAP button or PREV button. In the map screen, the distance to the next guide point and the turning direction will be displayed on the right side of the screen. How do I program a destination?5-37 ADJUSTING AND DELETING THE PRESET DESTINATION (waypoints) Using the joystick, you can adjust the destination (waypoints). Choose the destination (waypoints) you want to adjust on the [EDIT ROUTE] screen. 5-38 How do I program a destination? INV1870 INV1871 INV1872 4. INFO: When you move the joystick, the Adjust key will be displayed. 5. The new destination (waypoints) will be set. TO DELETE A DESTINATION 1. To delete the destination (waypoint), choose the destination (waypoint) in step 3 and select the Delete key. How do I program a destination?INFO: button to return to the To set a new destination (waypoints), refer to "Expert mode categories" or "Easy mode categories" on page 5-2. If you reset the new destination (waypoints), the older destination (waypoints) will be deleted. If you have requested a route calculation, the previous suggested route will be deleted from memory. The destination and waypoint can be deleted at one time. [. . . ] If the position marker does not move to the correct position even after the vehicle has been driven approximately 6 miles (10 km), adjust the current location. Please check the GPS indicator on the screen to see if it remains gray. If it remains gray, drive the vehicle to a place where the GPS can be received. The location of the vehicle icon will move by driving the vehicle for 30 minutes (in case it is running at 18-3/4 miles/hour (30 km/h)). [. . . ]