User manual NISSAN ALTIMA COUPE 2008

[. . . ] It was produced using the latest techniques and strict quality control. This manual was prepared to help you understand the operation and maintenance of your vehicle so that you may enjoy many miles (kilometers) of driving pleasure. A separate Warranty Information Booklet explains details about the warranties covering your vehicle. The "NISSAN Service and Maintenance Guide" explains details about maintaining and servicing your vehicle. [. . . ] By pressing this button you can select the item or perform this action. By touching this key you can proceed to the next function. To turn the system off, press the ON·OFF/VOL control knob. This vehicle may be equipped with Speed Sensitive Volume (SSV) for audio. AUDIO knob (Bass, Treble, Balance, Fade, and SSV): Press the AUDIO knob to change the mode as follows: Bass Treble Balance Fade Audio Bass To adjust Bass, Treble, Balance, and Fade press the AUDIO knob until the desired mode appears in the display. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. Once you have adjusted the sound quality to the desired level, press the AUDIO knob repeatedly until the radio or CD display reappears. Otherwise, the radio or CD display will automatically reappear after about 10 seconds. LHA0747 To change the SSV mode from 0 to 5, press the SETUP button. Then touch the "Audio" key, the audio settings screen will be displayed. While in this screen you can also adjust the other audio settings by touching the corresponding key. Once you have adjusted the sound quality to the desired level, touch the "Back" key repeatedly until the radio or the CD display reappears. Clock set For setting the clock, see "Adjusting the time" earlier in this section. Audio main operation ON·OFF/VOL control: Place the ignition switch to the ACC or ON position, then press the ON·OFF/VOL control knob while the audio system is off to call up the mode (radio or CD) which was playing immediately before the system was turned off. 4-38 Monitor, climate, audio, phone and voice recognition systems Track time displays the amount of time the current track has been playing. Satellite radio display Some satellite stations might broadcast information that shows up in the display. Depending on what the station decides to broadcast the following text might be displayed: LHA1009 FM/AM/SAT radio operation FM/AM/SAT band select: Pressing the RADIO button will change the band as follows: AM FM SAT When the RADIO button is pressed with the ignition switch in the ACC or ON position, the radio will come on at the station last played. No satellite radio reception is available unless there is an active XM satellite radio service subscription. If satellite radio is not operational then pressing the RADIO button will switch between FM and AM bands. If a compact disc is playing when the RADIO button is pressed, the compact disc will automatically be turned off and the last radio station played will come on. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. TUNE·FOLDER (tuning) knob: To manually tune the radio, turn the TUNE·FOLDER tuning knob to the right or left. CD display mode While listening to a CD or an MP3/WMA CD certain text might be displayed (when CD encoded with text is being used). Depending on how the CD or MP3/WMA CD is encoded the following text might be displayed during CD playback: Disc number displays which disc is playing Folder number displays the folder number on the CD that is being played. Track number displays the number of the track that is being played. Channel number displays the channel number of the selected satellite radio station. Category name displays the category name of the selected satellite radio station. Channel name displays the channel name of the selected satellite radio station. [. . . ] NISSAN designs its hoods with crumple zones to minimize the risk that the hood will penetrate the windshield of your vehicle in an accident. Nongenuine (imitation) parts may not provide such built-in safeguards. Also, non-genuine parts often show premature wear, rust and corrosion. Why should you take a chance? In over 40 states, the law says you must be advised if non-genuine parts are used to repair your vehicle. And some states have enacted laws that restrict insurance companies from authorizing the use of non-genuine collision parts during the new vehicle warranty. [. . . ]