User manual NINTENDO POKEWALKER

[. . . ] IMPORTANT: Before using this accessory, you must rst make a connection between the Pokéwalker and your Pokémon HeartGold or SoulSilver Version Game Card. Please refer to the instruction booklet included with the Game Card for complete information on making this connection. If the plastic tab doesn't completely pull out of the battery compartment, the Pokéwalker accessory may not operate. If the accessory does not work after pulling the plastic tab out, remove the battery cover and battery and check to see if part of the plastic tab is stuck in the battery compartment. [. . . ] This will vary depending on temperature, the number of steps taken, how often you actively use the accessory, how often you make an infrared communication, and how often you press the Button. 1 Using a small "+" style screwdriver, loosen the screw on the back of the accessory and remove the battery cover (or clip connector if it is already attached). 2 Remove the battery by sliding in the direction of arrow (1) and pulling it out of the battery compartment in the direction of arrow (2). If you are installing the clip connector, make sure the tab is inserted correctly into the Pokéwalker accessory, or it may not close correctly when the screw is attached. 4 Tighten the screw, making sure the clip connector is securely fastened. IMPORTANT: For best communication, avoid the following conditions, which can interfere with infrared communication: · Objects between the Nintendo DS and the Pokéwalker, or between two Pokéwalker accessories. You can also attach it with a strap (sold separately), however it may not measure steps accurately if you carry it using this method. NOTE: If using a strap, the Pokéwalker should be tucked in a pocket or other location where it doesn't hang loosely. Sitting on it could result in injury to the user or damage to the accessory. The optional clip connector can be used to attach it to a belt or other strap. see Section 10 , Changing the Battery / Clip Connector , for more information. When using the clip connector to attach to a belt, make sure the t is not too tight or too loose. This will help prevent damage to the clip connector or prevent the accessory from falling o . Periodically check to make sure that the accessory is securely attached to avoid dropping or losing it. NOTE: If you place the Pokéwalker accessory in your pocket or bag in Sleep Mode, this mode may be canceled if the Button is accidentally pressed for . The Pokéwalker accessory will keep track of and store the number of steps walked (see illustration) at a normal pace. You must then periodically transfer this information to the Game Card. this process is described in Section 5 and in the instruction booklet for the Game Card. In the following cases, the accessory may not be able to accurately record information: · Number of steps walked Perchlorate Material ­ special handling may apply. Leakage of battery uid can cause personal injury as well as damage to your accessory. [. . . ] ) Make sure there is nothing blocking or interfering with the infrared communication. Make sure the accessory is not in Sleep Mode by pressing the Button for at least . Make sure the plastic tab is completely removed from the battery compartment and that there is no foreign object in the compartment. IMPORTANT: If you accidentally wash the Pokéwalker accessory with your clothes or it gets submerged in water, follow these instructions: 1. [. . . ]