User manual NILFISK WST 100 DV

[. . . ] 6 Inspection prior to starting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Starting up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Starting the vacuum cleaner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Stopping - Emergency stopping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Before turning on the vacuum cleaner, fit the vacuum hose into the inlet (4) and then fit the required tool to the end of the hose. The float (11) stops the vacuuming operation (the vacuuming units remain activated) when the liquid container (2) is full; it is then necessary to turn off the vacuum cleaner and to empty the liquid container (2). 3 09/2009 WSS100 - WST100 DV Setting up - connection to the power supply WARNING!· · Make sure that the vacuum cleaner is in good condition before starting work. Before plugging the vacuum cleaner into the electrical mains, make sure that the voltage rating indicated on the data plate corresponds to that of the electrical mains. Plug the vacuum cleaner into a socket with a properly installed ground connection. The plugs and connectors of the connection cables must be protected against splashing water. Make sure that connections to the electrical mains and plug are correct. Use the vacuum cleaner only when the cables that connect to the electrical mains are in good condition (damaged cables could lead to electric shocks!). Regularly check that the electric cable does not show signs of damage, excessive wear, cracks or aging. When the vacuum cleaner is operating: · Do not crush, pull, damage or tread on the cable that connects to the electrical mains. · Only disconnect the cable from the electrical mains by removing the plug (do not pull the cable). · Only replace the electric power cable with one of the same type as the original (H05 VV-F); the same rule applies if an extension is used. · The cable must be replaced by the manufacturer's Service Centre staff or by equivalent qualified personnel. WARNING!The vacuum cleaner's power socket must be protected by a differential circuit-breaker with surge current limitation, that shuts off the power supply when the current discharged to the ground exceeds 30 mA for 30 msec. Never spray water on the vacuum cleaner: this could be dangerous for persons and could short circuit the power supply. · · · · · 09/2009 4 WSS100 - WST100 DV Vacuuming Liquids WARNING!Comply with the safety regulations governing the materials for which the vacuum cleaner is used. · · · · Before vacuuming, check that the float is present. If foam forms, turn off the vacuum cleaner iinediately and empty the container. Warning: switch off the vacuum cleaner iinediately if foam or liquid leaks out. Warning: the dirty liquid collected by the vacuum cleaner must be considered conductive. If it's used without the float, the vacuum cleaner may be seriously damaged. Technical specifications Parameter Voltage / frequency Power rating Noise level Protection Insulation Shaving capacity (optional) Max liquid capacity Inlet (diameter) Max vacuum Maximum air flow rate (without hose and reductions) Units V/Hz kW dB(A) IP Class gallons gallons in in H2O cfm WSS 100 / WST 100 DV 120/60 1. 6 73 44 I 6. 6 26 2 70 150 Maintenance and repairs WARNING!Disconnect the vacuum cleaner from its power source before cleaning, servicing, replacing parts or converting it to obtain another variant. [. . . ] The symbol (figure 13), which is present on the product or in its documentation, indicates that the product cannot be disposed of together with other domestic waste at the end of its life cycle. To prevent damages to the environment or the health caused by improper waste disposal, please separate this product from other waste and recycle it responsibly in order to support the sustainable reuse of material resources. Domestic users should contact the retailer or the local office providing information on separate collection and recycling of this product. Companies should contact the supplier and check the purchase contract terms and conditions. [. . . ]