User manual NILFISK VC300 ECO

[. . . ] Besides the operating instructions and the laws in force in the country where the vacuum cleaner is used, the technical regulations for ensuring safe and correct operation must also be observed (Legislation concerning environmental and labour safety, i. Do not perform any operation that could jeopardize the safety of people, property and the environment. Comply with the safety indications and prescriptions in this instruction manual. If an emergency situation occurs: filter breakage fire outbreak short-circuit motor block electric shock etc. [. . . ] Plug the vacuum cleaner into a socket with a correctly installed ground contact/connection. The plugs and connectors of the connection cables must be protected against splashes of water. Use the vacuum cleaners only when the cables that connect to the electrical mains are in perfect condition (damaged cables could lead to electric shocks!Regularly check there are no signs of damage, excessive wear, cracks or ageing on the electric cable. When the vacuum cleaner is operating, do not: Crush, pull, damage or tread on the cable that connects to the electrical mains. Only disconnect the cable from the electrical mains by removing the plug (do not pull the cable). Only replace the electric power cable with one of the same type as the original: H07 RN - F. The cable must be replaced by the manufacturer's Service Centre staff or by equivalent qualified personnel. Comply with the safety regulations governing the materials for which the vacuum cleaner is used. If the version for liquids is used: Make sure the liquid level sensor is working correctly before vacuuming liquids. If foam forms, turn off the vacuum cleaner immediately and empty the container. Tilting discharge device assembly Fasten the hopper to the filtering chamber, by inserting it into the relevant housings and, operating on the lever (2) to lock it (figure 9). Insert the bag (Longopac®) into the relevant support and fasten its end with the belt (1, figure 10). Engage the tilting discharge device support to the hopper by fastening it with the relevant pins (figure 9). Remove the bag (Longopac®) until it lays on the lower support platform and close its end with the supplied clamp. When the bag is full (Longopac®) close the upper end with two clamps by fastening them at 50 mm one from the other, then with a pair of scissors cut the bag between the two clamps (figure 10). The precautions described below must be taken during all the maintenance operations, including cleaning and replacing of the filter. To allow the user to carry out the maintenance operations, the vacuum cleaner must be disassembled, cleaned and overhauled as far as is reasonably possible, without causing hazards for the maintenance staff or other people. The suitable precautions include decontamination before disassembling the vacuum cleaner, adequate filtered ventilation of the exhaust air from the room in which it is disassembled, cleaning of the maintenance area and suitable personal protection. Compartments that are not dust-tight must be opened with suitable tools (screwdrivers, wrenches, etc. : check the air filter to find out whether the air-tightness of the vacuum cleaner has been impaired in any way and make sure that the electric control panel operates correctly. This inspection must be carried out by the manufacturer or by a competent person. [. . . ] Do not use the absolute filter again after having removed it from the vacuum cleaner. Make sure that connecting hose (1) is in a good condition and correctly fixed. If the hose is damaged, broken or badly connected to the unions, it must be replaced. When sticky materials are treated, check for possible clogging along the hose (2), in the inlet and on the baffle plate inside the filtering chamber. [. . . ]