User manual NILFISK T60SFA

[. . . ] Children must be supervised to make sure they do not play with the appliance. · If the supply cable is damaged, it must be replaced by the manufacturer or its service agent or similary qualified person in order to avoid a hazard. 2. Instructions for Use Before using the machine make sure that the voltage shown on the rating plate underneath the machine corresponds witht the mains voltage. · Do not use the machine without filters properly fitted. · This machine is not intended for the suction of hazardous materials or gas, doing so may expose people to serious health risks. [. . . ] · This machine is not intended for the suction of hazardous materials or gas, doing so may expose people to serious health risks. · The machine must not be used for the suction of water or other liquids. · Do not pick up sharp objects such as needles Original Instructions 3. 1 Start and Stop 3. 1. 1 Start Pull out the electric cable and plug the machine to a wall socket. Unplug by 3 Meteor grasping the plug, not by pulling at the cable. the overview image (page 2), replace the filter with a new one and close the cover again. 3. 2 Connecting hose, tube and nozzles 1. Push the adjusting button to extend the tube and pull back to shorten to desired length. Container full indication On the control panel a lamp is placed, where you will receive notification, when the container is full or the suction is degraded otherwise. The dust container must be emptied if the lamp is constantly on when the machine is operating at maximum power and the nozzle is raised from the floor. Container full indication 3. 5 Washing/exchanging the HEPA filter You will have access to the HEPA filter when you have released the dust container. Make sure to let the filter dry before putting it back into the vacuum cleaner. Please note that the machine will not function without a HEPA filter. 3. 6 Parking the tube and nozzle There are two grooves for parking. · Abuse, loss or lack of maintenance as described in Instructions for use. · If the machine has been used for suction of water, plaster dust or sawdust. setting up or connection, nor fire-damage, fire, lightning strike or unusual voltage fluctuations or any other electrical disturbances such as defective fuses or defective electrical installations on the supply grid, and defects or damage in general that Nilfisk-Advance consider to be the result of causes other than manufacturing and material defects. The guarantee becomes void: · If a defect is caused by the use of non-original Nilfisk filters. Trouble-shooting Repair or service of electrical components such as cable or motor, must only be carried out by an authorized service center. If the machine Check that the plug is does not start correctly fitted to the wall socket. The cable or plug may be damaged and must be repaired by an authorized service center. Reduced suction power The dust container may be full and needs to be emptied, see instructions. The HEPA filter may be blocked and has to be washed/exchanged, see instructions. The bent tube, hose, tube or nozzle may be blocked and needs to be cleaned. [. . . ] Reduced suction power The dust container may be full and needs to be emptied, see instructions. The HEPA filter may be blocked and has to be washed/exchanged, see instructions. The bent tube, hose, tube or nozzle may be blocked and needs to be cleaned. If the machine stops The thermal fuse may have blown, see instructions. 6. [. . . ]