User manual NILFISK SW 750

[. . . ] ­ ­ Spare Parts List (supplied with the machine) Service Manual (that can be consulted at Nilfisk Service Centers) All necessary operating, maintenance and repair procedures must be performed by qualified personnel or by Nilfisk Service Centers. Contact Nilfisk for service or to order spare parts and accessories, specifying the machine model and serial number. Nilfisk constantly improves its products and reserves the right to make changes and improvements at its discretion without being obliged to apply such benefits to the machines that were previously sold. Any change and/or addition of accessories must be approved and performed by Nilfisk. [. . . ] ­ Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects. ⭠Do not remove or modify the plates affixed to the machine. ­ Do not tamper with the machine safety guards and follow the routine maintenance procedures scrupulously. ­ Use only brooms supplied with the machine and those specified in the User Manual. ⭠In case of machine malfunctions , ensure that these are not due to lack of maintenance. Otherwise, request assistance from the authorised personnel or from an authorised Service Center. ­ Carefully read all the instructions before performing any maintenance/repair procedure. ­ To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of this Manual must be performed by the authorised personnel or by an authorised Service Center. ­ If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer. ­ The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries, plastics, etc. ), which are subject to standards that require disposal in special centres (see the Scrapping chapter). When turned to "I" the vacuum system and main broom are turned on; · When turned to "II" the vacuum system, main broom and side broom are turned on. Charged battery warning light (green) Semi-discharged battery warning light (yellow) Discharged battery warning light (red) Drive control lever Handlebar Handlebar adjusting knobs Filter shaker knob Hopper Front steering wheel Side broom Side broom lifting/lowering lever Side broom height adjusting knob Main broom Main broom height adjusting knobs Rear driving wheels Can holder Battery charger cable Battery charger cable housing Side broom motor circuit breaker Main motor circuit breaker Battery Dust filter Side broom motor Main motor Drive system gear Vacuum fan Battery charger 29. 5 A) Hood Hopper upper handle Hopper lower handles Serial number plate/technical data/conformity certification Side skirts Front skirt Rear skirt Drive belt adjuster In addition to the standard components, the machine can be equipped with the following accessories/options, according to the machine specific use: 1. General Cleaning width (without side broom) Cleaning width (with side broom) Machine size with folded handlebar and without side broom (length x width x height) Minimum distance from the floor (skirts not included) Main broom size (diameter x length) Side broom diameter Main broom speed Side broom speed Gradeability Hopper capacity Total machine weight (with standard battery) Front steering wheel size (diameter x length) Rear wheel size (diameter x length) Maximum drive speed Sound pressure level at workstation (ISO 11201, ISO 4871) (LpA) Machine output acoustic power (ISO 3744, ISO 4871) (LwA) Vibration level at the operator's arms (ISO 5349-1) Electrical components Electrical system voltage Standard battery Optional battery Battery charger Main motor Side broom motor Vacuum system motor Dust vacuuming and filtering Dust filter Dust filter surface Main broom compartment vacuum Values 500 mm 720 mm 998 x 797 x 501 mm 25 mm 200 x 500 mm 315 mm 335 rpm 100 rpm 2% 60 litres 68 kg 75 x 32 mm 300 x 45 mm 3. On some points of the machine there are some adhesive plates indicating: ­ DANGER ­ WARNING ­ CAUTION ­ NOTE While reading this Manual, the operator must pay careful attention to the symbols shown on the plates. Do not cover these plates for any reason and immediately replace them if they are damaged. The machine is supplied with a standard 12 V, 45 Ah GEL battery (which does not require maintenance). Make sure that there are no open doors/hoods and that the machine is in normal operating conditions. If the machine has not been used after being transported, check that all the blocks used for the transportation have been removed. Check that side and main broom are installed, otherwise install them (see the procedure in Maintenance chapter). Adjust the handlebar (6) to reach a comfortable position, by loosening the knobs (7). [. . . ] Before connecting the battery charger (B), ensure that frequency and voltage values, shown on the machine serial number plate (33), match the electrical mains voltage. In case of doubt, do not connect the plug to the electrical mains, but contact the qualified personnel. While charging the batteries, the red warning light (D) and the yellow warning light (E) turn on in sequence. The machine does not start when turning the main switch to "I" or to "II". [. . . ]