User manual NILFISK SW 700S B

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual NILFISK SW 700S B. We hope that this NILFISK SW 700S B user guide will be useful to you.


NILFISK SW 700S B : Download the complete user guide (5853 Ko)

You may also download the following manuals related to this product:

   NILFISK SW 700S B (5976 ko)
   NILFISK SW 700S B (5839 ko)
   NILFISK SW 700S B (5592 ko)
   NILFISK SW 700S B (5976 ko)
   NILFISK SW 700S B (6128 ko)
   NILFISK SW 700S B (5839 ko)
   NILFISK SW 700S B (5592 ko)
   NILFISK SW 700S B (5976 ko)
   NILFISK SW 700S B (5976 ko)
   NILFISK SW 700S B (6128 ko)
   NILFISK SW 700S B (5592 ko)
   NILFISK SW 700S B (5527 ko)
   NILFISK SW 700S B (5592 ko)

Manual abstract: user guide NILFISK SW 700S B

Detailed instructions for use are in the User's Guide.

[. . . ] The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal. Before performing any procedure on the machine, the operators and qualified technicians must read this Manual carefully. [. . . ] Debris container Debris container hook Debris container handle Manual filter shaker handle Main broom movable lid Main broom height left adjuster Main broom height right adjuster Main broom right lid Main broom right lid mounting screws Pedal brake on front wheel (optional) Main broom drive pulley Rear wheel drive pulley Vacuum fan Main motor Battery case Hood safety switch Serial number plate/technical data/conformity certification Position "0": The machine is off and all functions are disabled · In addition to the standard components, the machine can be equipped with the following accessories/options, according to the machine specific use: GEL batteries ­ Electronic battery charger ­ Main and side brooms with harder or softer bristles ­ Antistatic polyester or polyester BIA C dust filter ­ Electrical filter shaker ­ Front wheel with pedal brake ­ Skirts of various materials ­ For further information concerning the optional accessories, contact an authorised Retailer. General Machine length Machine width (without side brooms) Machine height (with lowered handlebar) Minimum/maximum handlebar height Cleaning width (without side broom) Cleaning width (with side broom) Minimum distance from the ground (skirts not included) Main broom size (diameter x length) Side broom diameter Main broom speed Side broom speed Front steering wheel Rear driving wheel (diameter x width) Total machine weight (without batteries) Debris container capacity Main broom and vacuum fan motor Side broom motor Filter shaker motor (optional) Sound pressure level at workstation (A Lpa) Vibration level at the operator's arms (*) Values 1, 070 mm 667 mm 836 mm 824/1, 120 mm 500 mm 720 mm 40 mm 265 mm x 500 mm 420 mm 400 rpm 52 rpm 125/37. Performance Maximum forward speed Gradeability Batteries Battery voltage Standard batteries Optional battery Minimum battery capacity Battery maximum capacity Battery compartment maximum size (length x width x height) Dust vacuuming and filtering Paper dust filter 5-10 m Main broom compartment vacuum Filter shaker activation CH1 C1 C2 EB1 ES1 F1 F2 F3 M1 M2 M3 R1 SW1 SW2 SW3 Battery charger Battery connector Battery charger connector Electronic board Electromagnetic switch Main fuse (60 A) Side broom fuse (15 A) Filter shaker fuse (15 A) Main broom motor Side broom motor Filter shaker motor Filter shaker relay Ignition switch Hood safety switch Filter shaker switch On some points of the machine there are some adhesive plates indicating: ­ DANGER ­ WARNING ­ CAUTION ­ CONSULTATION While reading this Manual, the operator must pay careful attention to the symbols shown on the plates. Do not cover these plates for any reason and immediately replace them if they are damaged. The machine requires one 12 V battery, or two 6 V batteries connected according to the diagram (40). NOTE If the machine is equipped with electronic battery charger (34), this must be connected to the batteries to allow the machine to operate. The machine can be supplied in one of the following configurations: a) WET or GEL batteries already installed on the machine b) WET batteries installed on the machine but without electrolyte c) Without batteries WET or GEL batteries already installed on the machine Open the hood (7) and check that the batteries are connected to the machine with the connector (33). Insert the ignition key (61) on the control panel and turn it to "I" without pulling the lever (4). Otherwise the batteries need to be charged (see the procedure in Maintenance chapter). If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician. Fill the battery cells with sulphuric acid for batteries (density from 1. For machine proper operation, the dust filter must be as clean as possible. To clean the filter while sweeping, turn on the filter shaker by proceeding as follows and according to the type of filter shaker installed: · manual filter shaker: Turn the ignition key to "0". Pull the handle (20) outward to the end of stroke, then suddenly release it; the inner return spring thus strikes the dust filter frame and shakes it. During this procedure the main motor and all functions are automatically cut-off. This interval can change depending on the dustiness of the area to be cleaned. Do not work on wet floors to prevent the dust filter from being damaged. The debris container (17) should be emptied after each working cycle and whenever it is full. With the handle (19) remove the debris container (17) and empty it into an appropriate container. After working, before leaving the machine, perform the following procedures. Clean the dust filter with the manual filter shaker (20) or the electrical filter shaker (67), if equipped. The machine can be pushed both with the ignition key (61) to "0" and to "I". [. . . ] 13) larger than 20 mm or cracks/tears (B) larger than 10 mm (for skirt replacement, refer to the Service Manual). If necessary, adjust the skirt height by using the slots on the screws (C and D, Fig. Charge the batteries when the yellow (63) or red warning light (64) turns on and at the end of each cleaning cycle. When the batteries are discharged, charge them as soon as possible, as that condition makes their life shorter. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE NILFISK SW 700S B




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual NILFISK SW 700S B will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.