User manual NILFISK SR 1000S B

[. . . ] The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. Contrôler la hauteur du sol des balais latéraux, en procédant comme suit : ­ porter la machine sur un sol plat et baisser les balais latéraux ; ­ en gardant la machine en position d'arrêt, baisser les balais latéraux et les faire tourner pendant quelques secondes ; ­ arrêter et soulever les balais latéraux, puis déplacer et arrêter la machine ; ­ contrôler que la trace laissée par les balais latéraux est, en extension et orientation, comme indiqué dans la figure (1 et 2, Fig. The purpose of this Manual is to provide the operator with all necessary information to use the machine properly in a safe and autonomous way. It contains information about technical data, operation, storage, maintenance, spare parts and safety. [. . . ] Disengage the parking brake according to the following procedure: ­ Press the pedal (6, Fig. Drive the machine to the working area, by keeping the hands on the steering wheel and pressing the pedal (5, Fig. C) on the front side to move forward and on the rear side to move backward. The drive speed can be adjusted from zero to maximum speed by increasing the pressure on the pedal (5, Fig. C) is equipped with a safety sensor, which allows the machine to be driven by pressing the pedal (5, Fig. The side brooms do not rotate when they are lifted, but they rotate when they are lowered. If this setting corresponds to the type of batteries installed on the machine, go to the next paragraph, otherwise perform the following procedures: ­ Disconnect the battery connector (6, Fig. Make sure that there are no open doors/hoods and that the machine is in normal operating conditions. If the machine has not been used after being transported, check that all the blocks used for the transportation have been removed. To turn off the main broom and the vacuum fan, turn the switch (9, Fig. Engage the parking brake according to the following procedure: ­ Press the pedal (6, Fig. After working, before leaving the machine: ­ Lift the side brooms with the lever (4, Fig. ­ Engage the parking brake according to the following procedure: ­ Press the pedal (6, Fig. Avoid stopping for a long time with the machine in the same position and the brooms rotating: this could create unwanted marks on the floor. To collect light and bulky debris, lift the front skirt by pressing the pedal (8, Fig. C); remember that while the front skirt is lifted, the machine vacuum power decreases. When operating on wet grounds, it is essential to turn off the vacuum system with the lever (3, Fig. For machine proper operation, the dust filter must be as clean as possible. To keep the dust filter clean while sweeping, turn off the vacuum system with the lever (3, Fig. During this procedure the main motor and the vacuum fan are automatically stopped. B) forward to turn on the main broom and the vacuum system, then start sweeping again. While working, repeat the procedure every 10 minutes on average (depending on the dustiness of the area to be cleaned). [. . . ] U) from the pulley (15); for a easier removal, turn the pulley (15) by operating on the vacuum fan (16) manually. N) larger than 20 mm or cracks (2) larger than 10 mm (for skirt replacement, refer to the Service Manual). R) slightly touches the ground and that it is not detached from the ground (1, Fig. Q) rotates upward of about 90° (as shown in figure); release the pedal and check that the skirt does not remain in an intermediate position but returns to its initial position. [. . . ]