User manual NILFISK SPIN 43 DS

[. . . ] 21 Manoeuvring the cleaner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 Supervising cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 3 Before starting the cleaner 4 Control/Operation 5 Applications and cleaning techniques 6 After cleaning 5. 1 Cleaning techniques . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 5. 2 Typical applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When cleaning and servicing the cleaner, replacing parts or changing mode of operation, switch off the cleaner and unplug it. General Use of the cleaner is subject to current national regulations. Besides the operating instructions and binding accident prevention regulations valid in the country of use, observe recognized regulations for safe and proper work. Do not use the cleaner on public paths and roads. Electrical connections CAUTION!Do not damage the power cord by riding over it, crushing or pulling it, etc. When using or replacing power cords, do not use any other cords than those specified by the manufacturer. 18 2 Description 2. 1 Purpose of the machine All single-disc cleaners are designed to clean and care for floor coverings inside buildings only. The manufacturer accepts no liability for any damage resulting from such use. Proper use also includes proper operation, servicing and repairs as specified by the manufacturer. Observe the relevant accident prevention regulations and any other generally accepted safety and working regulations. The manufacturer accepts no liability for damage resulting from any changes made to the cleaner by the user. Before using the cleaner, check whether floor coverings are suitable for this cleaning technique. The manufacturer accepts no liability for damage to the cleaner and the cleaned floor that is caused by the use of wrong brushes and cleaning agents. 2. 2 Product liability Please note that the cleaners may be used for their intended purpose only. If the cleaners are not used for their intended purpose, the user has the sole responsibility. The manufacturer accepts no liability whatsoever. + 2. 3 Operating elements 1 2 3 4 5 6 7 8 9 10 11 12 Shaft adjustment lever Guide handle Switch lock Socket (SPIN 43 HS) Brush motor switch Power cord Power cord hook Shaft adjustment joint Wheels Connector for waste hose Speed switch (SPIN 43 DS) Shaft Accessories (not included): 13 Spraymaster 14 Tank lever 15 Tank bracket 16 Liquid tank 17 Waste hose 18 Brush 19 Drive plate for pad 20 Pad 19 3 Before starting the cleaner 3. 1 Assembly For transport reasons, the motor head and the shaft are supplied not assembled. 1 2 1. Loosen the hexagon socket screws (1) in the shaft adjustment joint (2). Insert the shaft gently as far as possible into the shaft adjustment joint. Align the handle (3) parallel to the wheels (4) so that the open side of the shaft upper housing faces the rear (5). Wind the power cord around the handle and the power cord hook (6). 3 5 6 4 3. 2 Transport 1. Grasp the handle with both hands and tip the cleaner until it stands on the two wheels. When transporting the cleaner in elevators, observe current safety regulations, in particular with regard to carrying capacity. When transporting the cleaner in elevators, place the shaft in an upright position to prevent it from catching on elevator shaft walls. 20 4 Control/Operation 4. 1 Electrical connections CAUTION!Tip the cleaner on to its wheels and push it over accessory until the drive star and the brush flange are vertically aligned. Pull the shaft adjustment lever (1) and lower the shaft into its cleaning position. [. . . ] Letaliska 33 SLO-1110 Ljubljana Tel. : +368 15 24 23 06 Fax: +368 15 40 42 94 E-mail: wap. prodaja@siol. com SLOWAKIA Wap cistiace systémy spol. Vajnorská 135 83237 Bratislava Tel. : +421 7 44 25 96 64 Fax: +421 7 44 25 79 44 E-mail: wap@gtinet. sk Web: www. wap-alto. sk SPAIN ALTO Iberica S. L. 4 28760 Tres Cantos - Madrid Tel. : +34 91 8 04 62 56 Fax: +34 91 8 04 64 63 E-mail: info@alto-es. com SWEDEN ALTO Sverige AB Aminogatan 18 S-431 04 Mölndal Tel. : +46 3 17 06 73 00 Fax: +46 3 17 06 73 41 E-mail: info@alto-se. com SWITZERLAND ALTO Schweiz AG Allmendstr. 14 5612 Villmergen Tel. : +41 56 618 85 00 Fax: +41 56 618 85 10 E-mail: info@alto-ch. com USA ALTO U. S. Inc 16253 Swingley Ridge Road Suite 200 Chesterfield, MO 63017-1544 Tel. : +1 63 65 30 08 71 Fax: +1 63 65 30 08 72 E-mail: info@alto-us. com ALTO U. S. Inc 2100 Highway 265 Springdale, Arkansas 72764 Tel. : +1 50 17 50 10 00 Fax: +1 50 17 56 07 19 E-mail: info@alto-us. com ALTO U. S. Inc 1100 Haskins Road Bowling Green, Ohio 43402 Tel. : +1 41 93 52 75 11 Fax: +1 41 93 53 71 87 E-mail: info@alto-us. com SUBSIDIARIES AUSTRALIA ALTO Overseas Inc. [. . . ]