User manual NILFISK SO4500

[. . . ] 12. 5 English Guidance Congratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . We would like to take this opportunity to thank you for your purchase of the Nilfisk ALTO steam only cleaner. The SO4500 is manufactured in the EU to the highest quality Standards This instruction manual contains all of the necessary information to operate and maintain this machine. Please read this instruction manual carefully before you start using or carrying out any maintenance on the machine. [. . . ] Never use it on objects, which cannot resist the temperature (delicate materials, fabrics, plastics, wood etc). Where any doubt exists check carefully on a part of the material where minor marks will not matter. Do not operate the machine or carry out any maintenance out on it Unless you are trained and authorised to do so Unless you have read and thoroughly understand this instruction manual. · Operating Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Fill the cold water tank (Number 1 Diagram A) with clean cold water only. Anything other that clean cold water used in the Water tank will void the manufacturer's warranty. Connect the Steam Hose (Number 1 Diagram C) to the front of the machine (Number 3 Diagram A) ensuring it is pushed in all the way and the pin on the flap locks into the hole on the hose. To release the steam hose, lift the flap and pull. 7 English Operating Procedure cont. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . If the cable becomes damaged at anytime the complete cable must be replaced by a Nilfisk ALTO approved distributor. Never touch the power cable or plug with wet hands !! Always unplug the machine when i. When the Steam Ready LED (Number 9 Diagram B) illuminates the machine is ready to be used. · The fan switch on the hose handle will release steam when pressed. · Pressing the detergent switch located on the top of the handle will activate the detergent pump. The steam output can be adjusted by the steam control knob (Number 2 Diagram A) 13. Choose and fit the required accessory (Diagram C) to the hose handle. !! When changing accessories during use please note these will be hot. 8 English During Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Refill the cold water tank when the refill cold water LED (Number 11 Diagram B) is illuminated. A buzzer will sound and the steam will no longer come out of the nozzle when the steam switch on the handle is pressed. Once the cold water refill LED is illuminated the boiler heater will remain on for 30 minutes. If the cold-water tank is not refilled within 30 minutes and the machine is left powered on the boiler heater will switch off. Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Try in another wall socket Press On / Off switch which will illuminate when on Replace fuse with approved 13A fuse Call for service Turn the control to half way Wait for the "Ready to steam" light to illuminate Pour water into the clean water tank until the beeper stops. Call for service Wait for the "Ready to steam " light to illuminate Hold the steam switch on for approximately one minute, ever if just water is coming out. This will result in the heater coming back on Call for service Change and re grease "O" Rings. To avoid this happening ensure "o" rings are grease before every use. [. . . ]