User manual NILFISK SM 800

[. . . ] The declaration of conformity, supplied with the machine, certifies the machine conformity with the law in force. NOTE Two copies of the original declaration of conformity are provided together with the machine documentation. The machine model year is written in the declaration of conformity and it is also indicated by the first two figures of the machine serial number. Use the following table to write down the machine identification data. [. . . ] ­ Do not collect burning cigarette butts or other burning objects, ash, matches or similar. ­ To remove glass, metals or sharp objects from the collection tank, wear thick gloves to prevent personal injuries. ­ This sweeper must be used in dry conditions, it must not be used or kept outdoors in wet conditions. ­ Use only brooms supplied with the machine or those specified in the User Manual. ­ Before using the sweeper, doors and covers must be as shown in the User Manual. ­ During the sweeper operation, foreign materials may get into the eyes of the operator. Do not use the machine when tired, absent-minded, under the effect of drugs, alcoholics or medicines which can compromise the control over the machine. General Cleaning width with side brooms Main cylindrical brush cleaning width Machine size with folded handlebar (length x width x height) Machine size with unfolded handlebar (length x width x height) Main broom size (diameter x length) Side broom diameter Collection tank capacity Machine total weight Values 820 mm 450 mm 890 x 820 x 345 mm 1, 300 x 820 x 1, 030 mm 150 x 450 mm 260 mm 34 L (theoretical) - 19 L (actual) 16 kg This sweeper has been designed to clean flat and paved surfaces. The manufacturer is not responsible for damages coming from failure to follow these instructions. The manufacturer is not responsible for damages coming from unauthorised machine modifications. If necessary, adjust the handlebar (1) to one of the 3 positions, by using the knobs (2). Grab the handlebar and push the machine forward no faster than a normal walking pace. If the machine is to be used on wet floors, use it only for short intervals. The collection tank (3) should be emptied after each working cycle and whenever it is full. Lift the collection tank with the handle (4) in the front side and empty it into a proper container. Install the collection tank on the machine by inserting the lower end into the machine frame (12). Slightly press downwards until the collection tank is in the proper position. It is advisable to empty the collection tank after each use and whenever it is necessary. After working, before leaving the machine: empty the collection tank (4) and check the main brooms (8 and 9) to remove foreign materials (lace, wire, strings or similar) which can compromise the proper operation. The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. [. . . ] Pay attention to the proper position of the long driving belt (D, Fig. It is advisable to wear protective gloves when replacing the brooms because there can be sharp debris between the bristles. Except the procedures shown in this Manual, the operator should not try to perform other repair procedures on the machine. repair and services must be performed by Nilfisk authorize technicians. [. . . ]