User manual NILFISK SDM 43-DUO

[. . . ] The relevant accident prevention regulations as well as all the generally acknowledged safety and working practices must be followed. unauthorized modifications to the machine exclude the manufacturers liability for resultant damage. Before machine use, floorcoverings must be tested for suitability for this cleaning process. In gymnasiums The manufacturer accepts no liability for damage to equipment and to the floor being cleaned from using the wrong brushes and cleaning agents. [. . . ] Then tip the machine onto its wheels (9) and press the brush motor switch (2) briefly. Remove the plug from the power socket and wind the electric cable (18) around the handle bar (1) and cable hook (8). Thorough cleaning the easy way For thorough cleaning, the single-disc machine is supplied with the following accessories: Liquid tank (13) Scrubbing brsuh (11) or drive plate with black pad (19). control the flow of liquid with the tank lever (15) by pulling the lever (15) upwards. Vacuum the dirty wash solution a section at a time with a water extractor. Please remember that the voltage in the building being cleaned must concur with that given on the machines type plate. Assembly instructions The motor head and bar are supplied separately packed. First release the hexagon socket srews in the shaft adjustment unit (17). Then feed the bar (7) gently as far as it will go into the shaft adjustment unit (17). Preparations for use Grasp the handle bar (1) with both hands and tip the machine until it is resting on both wheels (A). Then wheel the machine to its place of work and plug the electric cable into the power supply. Now tip the machine back onto the wheels and push it over the brush (or drive plate) until the drive star and brush flange are vertically aligned. Then squeeze the shaft adjustment lever (5) and lower the bar (7) into its working position. Align the machine horizontally above the working element (brush or drive plate), press the switch lock (4) and press the brush motor switch (2) briefly. If you keep the bar in its central position, the machine works on the spot. For shampooing, the machine is equipped with the following accessories: - Liquid tank; 0. Meter a small amount of liquid until the bristles are saturated with foam. Run the machine with the rotating brush from right to left or viceversa. Immediately after this, run the machine in the same way in the reverse direction, but with an overlap of about a quarter of the strip already treated (E. ) Only then run the machine in a spiral pattern over the shampooed strips. ) During shampooing it is highly advisable to immediately remove the dirt-laden foam a section at a time with a water extractor. Fit the holder for the spray can to the bar (7) with the holder pointing upwards and, when viewed from the operating side, to the left (G). [. . . ] never use highly flammable , combustible , toxic , healthhazardous , corrosive or irritant substances. Repairs, including the fitting of spray agent lines and hoses, may only be carried out by approved customer service shops or by specialists in this field who are familiar with all the relevant safety regulations. When the machine is not being used, store it in a dry place and in normal room conditions (not below under 0°C). Rated power Brush (rpm) Brush (mm) Working height (mm) Working weight (kg) GB The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. [. . . ]