User manual NILFISK SC800

[. . . ] This manual will help you get the most from your NilfiskTM automatic scrubber/dryer. Note: Bold numbers in parentheses indicate an item illustrated on pages 5-8 unless otherwise noted. Repairs, when required, should be performed by your Authorized Nilfisk Service Center, who employs factory trained service personnel, and maintains an inventory of Nilfisk original replacement parts and accessories. Please specify the Model and Serial Number when discussing your machine. [. . . ] NOTE: EcoFlex machines can either be used conventionally with detergent mixed in the tank or the EcoFlex detergent dispensing system can be used. When using the EcoFlex detergent dispensing do not mix detergent in the tank, plain water should be used. Lower the squeegee, move the machine ahead slightly and adjust the squeegee tilt using the Squeegee Adjustment Knob (23) so that the rear squeegee blade touches the floor evenly across its entire width and is bent over slightly as shown. COMMON INSTRUCTIONS: Pressing and releasing the Detergent Switch (E) while the solution system is active will cause the detergent system to alternately turn on and off. The system should be purged of previous detergent when switching to a different detergent. SERVICE NOTE: Move machine over floor drain before purging because a small amount of detergent will be dispensed in the process. When the Detergent Cartridge is almost empty a Display Panel (F) indicator will come on. This "Low Detergent" indicator will remain on until you reset the system. Once this indicator comes on you should be able to simply pour an entire gallon bottle of detergent into the Cartridge to refill without worrying about measuring. When switching cartridges, the "Low Detergent" indicator is only accurate if the replacement cartridge is at the same level as the cartridge being replaced. Press and hold together the Solution Increase Switch (B) and the Solution Decrease Switch (D) down for 3 seconds. To change the percentage, the detergent system must be OFF, then press and hold the Detergent ON/OFF Switch (E) for 2 seconds. The detergent indicator will flash and each press of the switch will cycle through the available percentages (3%, 2%, 1. Once the desired percentage is displayed on the screen (F5), stop and it will lock in after 5 seconds. SERVICE NOTE: Remove the detergent cartridge from the detergent box prior to filling to avoid spilling detergent on the machine. It is recommended that a separate cartridge be used for each detergent you plan to use. The detergent cartridges have a white decal on them so you can write the detergent name on each cartridge to avoid mixing them up. When installing a new cartridge, remove the Cap (AA) and place the cartridge in the detergent box. This will display the control panel indicator lights, reference the Battery Condition Indicator (F6) and Hour Meter (F1) before proceeding. 3 To transport the machine to the work area, push the Drive Paddle (29) forward to go forward or pull the Drive Paddle (29) backward to move the machine in reverse. vary the pressure on the Drive Paddle (29) to obtain the desired speed. NOTE: Speed Control Knob (30) is used to control the maximum speed in either forward or reverse. [. . . ] Wash the tops of the batteries with a solution of baking soda and water (2 tablespoons of baking soda to 1 liter of water). EcoFlex - Charge the batteries each time the machine is used or when the Battery Indicator (F6) is reading less than full. * Remove all jewelry * Do not smoke * Wear safety glasses, rubber gloves and a rubber apron * Work in a well-ventilated area * Do not allow tools to touch more than one battery terminal at a time * ALWAYS disconnect the negative (ground) cable first when replacing batteries to prevent sparks. Your voltage regulated lead acid (VRLA) battery will deliver superior performance and life ONLY IF IT RECHARGED PROPERLY! [. . . ]