User manual NILFISK SALTIX 3

[. . . ] Depending on the number of running hours ­ the dust filters (dust bag, sackfilter and motor filter) should be renewed. a dust bag must be fitted in the machine if the vacuum cleaners sack filter is vacuumed. Keep the container clean with a dry cloth, and a small amount of spray polish. Use of non original dust bags or non original filters can cause restricted air flow which may lead to machine overload. [. . . ] No changes to the mechanical, electrical or thermal safety devices must be made. This machine is equipped with a thermal cut-out to protect the motor and other vital machine parts from overheating. Should the machine cut out, you will have to wait at least 5-10 minutes for it to automatically reset. While you are waiting, switch the machine off and unplug it, then check the hose, dust bag and filter to be sure that nothing is blocking the flow of air through the machine. Recycling the vacuum cleaner As specified in European Directive 2002/96/EC on old electrical and electronic appliances, used electrical goods must be collected separately and recycled ecologically. Contact your local authorities or your nearest dealer for further information. Rated power Protection grade (moist, dust) Protection class (electrical) Airflow with hose and tube Vacuum, at nozzle Suction power with hose Sound power IEC 704 2. The equipment meets the requirements in EN 61000-3-11, and connection to the public mains is possible following consultation with the power supplier. The equipment may only be connected to the mains with a network impedance that is below 0. Network impedance at the point of delivery can be obtained from the power supplier. If the mains has a higher network impedance, momentary drops in mains voltage may occur during start/operation of the equipment. Specifications and details are subject to change without prior notice. THIS VACUUM CLEANER is designed, developed and rigorously tested to function efficiently and safely when properly maintained and used in accordance with the following instructions. These instructions have been prepared with safety and efficiency paramount. THE MACHINE OPERATOR must be trained by a suitably qualified instructor and must understand these instructions for use, and be made aware of any relevant regulations and legislation in force at the time of use. CAUTION - This machine is not suitable for use in explosive or inflammable atmospheres or where such atmospheres are likely to be produced by the presence of volatile liquid or inflammable gas or vapour. CAUTION - In no circumstances should the power supply cord be wrapped around fingers or any part of the operators person. CAUTION - The electrical supply plug must not be subjected to undue stress by pulling on the power supply cord. yOUR MACHINE must only be connected to an electrical supply of the same voltage and frequency as indicated on the rating plate. Ensure that the plug fitted to the end of the power supply cord is suitable for your supply socket, if not refer to the information contained in `Electrical Connections', or consult a qualified electrician. [. . . ] This machine is double-insulated and no earth connection is necessary. The blue wire must be connected to the terminal in the plug which is marked with the letter `N' or is coloured black or blue. The brown wire which must be connected to the terminal in the plug which is marked with the letter `L' or is coloured red or brown. If the plug to be fitted does not conform to the above notation then consult a qualified electrician. [. . . ]