User manual NILFISK S3H

[. . . ] Check hydraulic oil level X 9 Move the machine to a clean, dry storage area. A B C D E F G H I J K L M N O P Q * R S T U V W X Y Z AA BB CC DD EE FF GG HH II JJ KK LL MM NN OO PP QQ Low Fuel Indicator (LP) Horn Switch Engine Service Indicator (triggered by ECU) Headlight Switch Glow Plug Indicator (Diesel / Release key after indicator turns OFF) Hydraulic Filter Plugged Indicator Engine Speed Switch Scrub Pressure Decrease Switch Scrub Pressure Increase Switch Scrub Pressure Display Solution Switch Solution Tank Empty Indicator Recovery Tank Full Indicator Side Broom DOWN/ON Switch Main Broom ON Indicator Light Sensor Shaker Switch Dust Filter Plugged Indicator (right) Open Dump Door Switch Hopper Open Indicator Hopper Overtemp Indicator Close Dump Door Switch Lower Hopper Switch Raise Hopper Switch Dust Control Switch Side Broom UP/OFF Switch Vacuum System Switch Scrub System OFF Switch Coolant Temperature Gauge Oil Pressure Gauge Fuel Gauge (Gas / Diesel) Voltmeter Brake Pedal Parking Brake Latch Solution Flow Control Lever Main Broom Raise/Lower (ON/OFF) Lever Main Broom Adjust Knob Hopper Safety Support Lever Control Panel Ignition Switch Tilt Wheel Lever Drive Pedal Hour meter Main Broom Overload Indicator Light Since the Main Broom Motor always turns in the same direction, the bristles on the broom eventually become curved, reducing sweeping performance. Sweeping performance can be improved by removing the broom and turning it around (end-for-end). [. . . ] The main broom should be replaced when the bristles are worn to a length of 2-1/2 inches (6. The main broom stop (JJ) must be re-adjusted when the broom is replaced. NOTE: The machine should be stored with the Main Broom in the raised position. Remove the large T-Bolt (A1) from the side of A1 B1 the broom idler arm. Pull the main broom out of the broom housing and remove any string or wire wrapped around it. Also inspect the skirts at the front, back and sides of the broom housing. The skirts should be replaced or adjusted if they are torn or worn to a height of more than 1/4 inch (6. Turn the broom around (end-for-end) and slide it back into the B1 broom housing. This valve prevents damage to the hydraulic system when the machine is being towed/pushed short distances without use of the engine. Turn the valve 90 degrees; this disengages the hydrostatic lock between the motor and pump. The hydrostatic pump can be damaged if the machine is towed with the valve in the normal working position (A3). Reference the illustration below for the normal working setting (A3) and the free wheeling towing setting (B3). Note: If the tow valve is left in free wheeling (B3) position the hydrostatic pump can't drive the machine FWD or REV. no damage will result , just re-set valve to the normal working setting (A3). Tow or push machine no faster than a normal walking pace (2-3 miles per hour) and for short distances only. If the machine is to be moved long distances the rear drive wheel needs to be raised off the floor and placed on a suitable transport dolly. [. . . ] The side broom(s) are adjusted simply by pressing and holding the Side Broom DOWN/ON Switch (N) or the Steering Rack Side Broom UP/OFF Switch (Y) until the desired amount of bristles are contacting the floor. Once every 150 hours pump a small amount of grease onto the steering rack and pinion NOTE: The machine should be stored with the Side Broom(s) in the raised position. Also every 150 hours apply light machine oil to maintain free movement of all general pivot points. [. . . ]