User manual NILFISK RS 1301

[. . . ] The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. AQ) comme indiqué dans la figure (la figure montre l'inclinaison du troisième balai vue du siège de conduite). AQ) comme indiqué dans la figure (la figure montre l'inclinaison du troisième balai vue du siège de conduite). This Manual is an integral part of the machine; its purpose is to provide the operator with all necessary information to use the machine properly in a safe and autonomous way. [. . . ] The video-camera system can be turned on manually or automatically with the drive pedal. When the machine is in "neutral" (drive pedal not pressed), to turn on the video system (1, Fig. BA) and the cameras (4 and 5), press the switch (2) when the ignition key (24, Fig. The display shows the front or rear camera whether the pedal is pressed for forward or reverse gear. To turn on the salt spreader, press the lower part of the switch (17, Fig. Lower and start the snow brush by pressing the lower part of the switch (17, Fig. To lift the snow brush, stop the snow brush by pressing the upper part of the switch (17, Fig. BE), check its height from the ground according to the following procedure. Keep the machine stationary, lower the snow brush completely and let it rotate for few seconds. Stop and lift the snow brush, then move the machine aside and engage the parking brake. Tilt the snow brush assembly as necessary by using the suction inlet shifting controls (21 and 22, Fig. After using the equipment, ensure that the snow brush is stopped by pressing the upper part of the switch (52, Fig. After working, before leaving the machine, perform the following operations. E) to idle, and hold it in this position for a few minutes to let the system stabilize. If necessary, bring the 3rd broom from opened position to closed position according to the following procedure: · Otherwise bring it to the above-mentioned position by pressing and holding the switch (34, Fig. G) from opened position to closed position by pushing the joystick (46, Fig. G) safely, only when the arm extension (22) is to the left or right end of stroke. In this situation the arm shifting angle is limited by proper safety devices. In other situations, the shifting angle is limited to avoid damaging the machine or affect its stability. It is therefore advisable to bring always the 3rd broom arm extension (22, Fig. G) to closed position, only when the arm extension (22) is to the right end of stroke. clean the hopper , the filters and the suction pipe , check the gaskets and lubricate the suction fan bearings , as shown in Maintenance chapter. [. . . ] The display has stopped because there is an error in the connections ("bottle" symbol with exclamation mark). The indications on the display are correct and they state that there is water. The tachometer sensor is working properly and the display indicates the correct speed of the machine. Possible cause The high pressure switch is on, the warning light is off, the display is switched to "work" mode. [. . . ]