User manual NILFISK POSEIDON 5-53 PE

[. . . ] During operation of the washer, recoil forces are produced at the spray lance and, when the lance is held at an angle, a torque is also created. Do not direct the jet towards yourself or towards other persons in order to clean clothes or footwear. Do not use the washer when other people without protective General Use of the high-pressure washer is subject to the applicable local regulations. In addition to the operating instructions and the binding accident prevention regulations in the country of use, the generally recognised rules for safe working must also be observed. [. . . ] Pull the lance (or other accessory) forward to check that it is securely attached to the spray gun. Always remove any dirt from the nipple before connecting the lanse to the spray gun. 4. 1. 2 Connecting the high pressure hose and the water hose 1. Connect the high pressure hose to the high pressure inlet by means of the quick coupling. Before connecting the water hose to the washer, rinse the water hose briefly to prevent sand and other dirt from entering into the washer. See chapter 8. 3 for required quantity of water and water pressure. In the case of poor water quality (sand, etc. ), we recommend that a fine water filter is fitted in the water inlet. 4. 1. 3 Fuelling WARNING!Always shut off the engine and let it cool for at least two minutes before fuelling. If you do spill fuel when fuelling, do not start the engine before the spilled fuel has evaporated. If the washer is on a trailer, any fuel spills must be wiped up before the machine is started. Never expose the machine to an open flame. Note: Never operate the machine in a closed room; the exhaust fumes are dangerous. Follow the safety instructions in chapter 1! 4. 2 Start the washer 4. 2. 1 Switching on the washer when it is connected to a water supply 1. Operate the spray gun several times at short intervals to vent the system. 4. 2. 2 Switching on the washer when it is connected to open tanks (suction mode) 1. Before connecting the suction hose to the washer, fill the hose with water. machine run without spray lance mounted until all air has escaped. For automatic suction from a tank, watercourse or similar supply, the inlet hose must be filled with water before you start. suction height (see section 8. 3 Technical Data) is reached with cold water (up to 8°C). With 70°C/60°C warm water, the machine must be under or at the water level. When using this machine in suction mode, first ensure that the system has been bled of air by letting the 20 If the water being suctioned contains particles, a suction filter must be mounted on the end of the hose. In case of risk of running sands, a sand filter must be attached. EN 4. 3 Using detergents Detergent can be added by means of the detergent injector. 1. Never allow detergent to dry on the surface to be cleaned as this may cause damage. 5 After using the washer 5. 1 Stop the pressure washer 1. Remove the water hose from the washer. 21 EN 5. 3 Storing the washer (frost-protected) 1. If the high-pressure washer is stored in a room with temperatures around or below 0°C, anti-freeze should be drawn into the pump beforehand: 1. Connect the suction hose to the water inlet of the washer and place it in a tank containing anti-freeze. Hold the spray gun over the tank containing anti-freeze and activate it to start suction of anti-freeze. Lift the suction hose from the tank containing anti-freeze and activate the spray gun to pump out the remaining antifreeze. [. . . ] 10 08302 Mataró Tel. : +34 902 200 201 Fax: +34 93 757 8020 E-mail: mkt@nilfisk-advance. es www. nilfisk-alto. com SWEDEN Nilfisk-Advance (Shenzhen) Ltd. Commercial & Trade CEnter Fuitian Free Trade Zone 518038 Shenzhen Tel. : +86 755 8359 7937 Fax: +86 755 8359 1063 CZECH REPUBLIC Nilfisk-Advance Kereskedelmi Kft. Rákóczi Ferenc út 10 2310 Szigetszentmiklos-Lakihegy Tel: +36 2447 5550 Fax: +36 2447 5551 E-mail: info@nilfisk-advance. hu Sales: ertekesite@nilfisk-advance. hu Service: service@nilfisk-advance. hu www. nilfisk-advance. hu ITALY ALTO Sverige AB Member of Nilfisk-Advance Group Aminogatan 18, Box 4029 431 04 Mölndal Tel. : +46 31 706 73 00 Fax: +46 31 706 @nilfisk-alto. se www. nilfisk-alto. se TAIWAN ALTO Ceská Republika s. r. o. Zateckých 9 14000 Praha 4 Tel. : +420 24 14 08 419 Fax: +420 24 14 08 439 E-mail: info@alto-cz. com DENMARK Nilfisk-ALTO Divisione di Nilfisk-Advance A/S Località Novella Terza 26862 Guardamiglio (LO) E-mail: d. puglia@nilfisk-advance. it JAPAN Nilfisk-Advance Taiwan Branch No. [. . . ]