User manual NILFISK P 160.2 X-TRA

[. . . ] If you find any, do not start up your machine 62 Especially check: The insulation of the electric cable should be faultless and without any cracks. never direct the water jet at persons , pets , live electrical equipment or the machine itself. Never try to clean clothes or footwear on yourself or other The operator and anyone in the immediate vicinity of the site of cleaning should take action to protect themselves from being struck by debris dislodged during operation. This appliance has been designed for use with cleaning agents supplied or recommended by the manufacturer. [. . . ] This high pressure washer is only allowed to be connected with the drinking water mains, when an appropriate backflow preventer has been installed, Type BA according to EN 1717. 1 Application This high-pressure washer has been developed for domestic use for cleaning: - Car, motorbike, boat, caravan, trailer, patio/drive/flagstones, woodwork, brickwork, barbecue, garden furniture, lawn mower Section 5 describes the use of the high-pressure washer for vaious cleaning jobs. Only use the high-pressure washer for purposes described in this manual. The safety precautions must be observed to prevent damage to the machine, the surface to be cleaned or severe personal injuries. 1 Start/stop switch 2 Water inlet (with filter) 3 High pressure connection (only machines without hose reel) 4 High pressure hose 5 Electric cable 6 Button for regulation of pressure and water volume 7 Ergo 2000 spray handle with lock (7a) 8 Flexopower Plus spray lance 9 Turbohammer Plus spray lance 10 Detachable detergent container 11 Nozzle cleaning tool 12 Dosing of detergents 13 Hose reel 14 Hose hook (only machines without hose reel) 15 Model tag 16 Button for telescopic handle 17 Telescopic handle 18 Turnable cable hook Specifications: See model tag (15) of machine. 3 Before you start using your pressure washer Note: the hose hook can be mounted on the front as well as on the back. Front position is to be used if the product is used together with a special wall hook for wall storage. Note: The inlet filter must always be fitted in the water inlet pipe to filter out sand, limestone and other impurities as these will damage the pump valves. 1 Connection of high pressure hose Machines without hose reel: Attach the high pressure hose (4) to the high pressure connection of the machine (3). Insert the nipple of the spray lance (B) into the quick-release connection and release it. Pull the spray lance (or other accessory) forwards to check that it is securely attached to the spray gun. Always remove any dirt from the nipple before connecting the spray lance to the spray handle. Let the water run through the water hose before connecting it to the machine to prevent sand and dirt from penetrating the machine. Note: Check that the filter is fitted in the water inlet pipe and that it is clean and free from debris. Connect the water hose to the water supply by means of the quick connector (inlet water, max. To raise or lower the handle, press the button (16) and move the handle upwards or downwards. The spray lance is affected by a thrust during operation - therefore always hold it firmly with both hands. Activate the trigger of the spray handle and let the water run until all air has escaped from the water hose. [. . . ] 3 Storage of accessories The standard accessories (spray handle, spray lance (A) and nozzle cleaning tool) can be stored on the pressure washer. Always disconnect the electrical plug from the socket prior to maintenance or cleaning. To ensure a long and problem free working life, please take the following advice: Wash off water hose, high pressure hose, spray lance and accessories before mounting. Any repair should always be made in an authorized workshop with original spare parts. [. . . ]