User manual NILFISK MX 107 C

[. . . ] · If the machine is not working as it should, has been dropped, damaged, left outdoors or flooded with water, return it to a service center. · Do not pull the machine by the cord, do not use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. Replace the cord or unplug immediately if the ground prong becomes damaged. [. . . ] Replace the cord or unplug immediately if the ground prong becomes damaged. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. · Keep loose clothing, hair, fingers, and all parts of body away from openings and moving parts. · Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes, or any health endangering dusts. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present. · Liquid ejected at the spray nozzle could be dangerous as a result of its temperature, pressure, or chemical content. 2 INSPECTION: Carefully unpack and inspect your MX 107 C for shipping damage. You should notify the carrier immediately if you notice damage to the box or to the machine or parts. CLEANING SOLUTIONS: We recommend liquid cleaning chemicals. Powder chemicals may be used, but unless mixed very thoroughly they could cause a build-up in the pump, lines, and/or quick disconnects. Undissolved powder can plug the solution pump, the hose, or the spray tool. Connect the hose assembly (6) to the machine; make sure the quick disconnects are locked together. If the main switch is not turned on, the motors (pump and vacuum) will not turn on with the rocker switch. Set the rocker switch to the UP position to turn on both the vacuum motor and the solution pump. NOTE: with the rocker switch in the DOWN position, only the vacuum motor will turn on. Place the cleaning tool on the stain and squeeze the trigger while pulling back on the tool. When the fluid reaches the recovery tank full indicator, turn OFF the power switch, unplug the power cord, and move the machine to a designated waste water "DISPOSAL SITE". Doing so will damage the vacuum motor and damage is NOT COVERED by WARRANTY. [. . . ] Place the cleaning tool on the stain and squeeze the trigger while pulling back on the tool. When the fluid reaches the recovery tank full indicator, turn OFF the power switch, unplug the power cord, and move the machine to a designated waste water "DISPOSAL SITE". Doing so will damage the vacuum motor and damage is NOT COVERED by WARRANTY. [. . . ]