User manual NILFISK IVB 5 WET-15 QUICK GUIDE

[. . . ] The Model and Serial Number of your machine are shown on the Nameplate in the battery compartment. This information is needed when ordering repair parts for the machine. Use the space below to note the Model and Serial Number of your machine for future reference. When the machine is delivered, carefully inspect the shipping packaging and the machine for damage. [. . . ] Carefully lift the batteries into the battery compartment and arrange them exactly as shown in FIGURE 1. Position the cables so the battery caps can be easily removed for battery service. Carefully tighten the nut in each battery terminal until the terminal will not turn. Do not over-tighten the terminals, or they will be very difficult to remove for future service. Coat the terminals with spray-on battery terminal coating (available at most auto parts stores). Put one of the black rubber boots over each of the terminals and connect the Battery Pack Connector (15). Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels. To mount the Brushes (AA) (or pad holders) align the Lugs (BB) on the brush with the holes on the mounting plate and turn to lock in place (turn the outside edge of brush towards the rear of machine as shown (CC)). Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels. Slide the brush into the housing, lift slightly, push and turn until it seats. The solution should be a mixture of water and the proper cleaning chemical for the job. NOTE: Speed Control Knob (30) is used to control the maximum speed in either forward or reverse. 4 Press and hold the Solution Switch (C) for 5 seconds to pre-wet the floor. NOTE: This must be done prior to pressing the Scrub ON/OFF Switch (H). 5 Press the Scrub ON/OFF Switch (H), the scrub pressure will default to Normal (one scrub pressure indicator lit). Use the Scrub Pressure Increase Switch (G) and Scrub Pressure Decrease Switch (I) to change between Regular and Heavy Scrub modes. the solution flow rate will automatically adjust to coincide with the scrub pressure. NOTE: The solution flow rate can be changed independently of the scrub pressure by pressing the Solution Increase Switch (B) or Solution Decrease Switch (D). Any subsequent scrub pressure adjustments will reset the solution flow rate to correspond with the scrub pressure. NOTE: The scrub, solution, vacuum and detergent (EcoFlex models) systems are automatically enabled when the Scrub ON/OFF Switch (H) is pressed. Any individual system can be turned OFF or back ON by simply pressing its switch at any time during scrubbing. 7 When the Drive Paddle (29) is in the neutral position, the scrub, vacuum, solution and detergent (EcoFlex models) systems are activated but not running. [. . . ] EcoFlex - Charge the batteries each time the machine is used or when the Battery Indicator (F6) is reading less than full. To avoid damage to floor surfaces, wipe water and acid from the top of the batteries after charging. After charging the batteries, remove the vent caps and check the water level in each battery cell. Use distilled or demineralized water in a battery filling dispenser (available at most auto parts stores) to fill each cell to the level indicator (or to 10 mm over the top of the separators). [. . . ]