User manual NILFISK IVB 5-M

[. . . ] Turn on the unit and inspect the seal between the motor head and filter chamber. If you suspect the gasket between the filter chamber and the collection can is not sealing properly: 1. Loosen the screws "A" that lock filter chamber "B" against the vacuum structure. [. . . ] Turn on the unit and inspect the seal between the filter chamber and the collection can. Turn off the vacuum cleaner by rotating the main switch back to the "OFF" position (Figure 1). If the performance of the vacuum cleaner decreases during use, it may be necessary to clean the primary filter: 1. Wait a few minutes for the dust to settle at the bottom of the container. Slide the container out from the machine and carry the container by the handle (figure 4). Remove old HEPA cartridge by carefully pulling cartridge through the posts. Carefully install new HEPA cartridge against the foam gasket with the label facing out. Raise one side of the filter and reach down under the filter with one hand to remove split pin "D". Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. This equipment is only certified for explosion-proof operation if it is equipped with the proper conductive hose and tools. Any alteration to this equipment by a third party will nullify its certification. Nilfisk warrants that its equipment will be free of defects in workmanship or material for a period of two years from the date of delivery. If the vacuum fails to meet these warranty standards, Nilfisk shall, upon notification within such time period, correct such non-conformity, at its option, either by repairing any defective part or parts, or by replacing a part or parts provided that the equipment is returned to an authorized Nilfisk service facility. Equipment shall not be returned without advance notice to, and consent of Nilfisk. Correction of non-conformities or defects in the manner and for the period of time provided above, shall constitute fulfilment of all Inabilities of Nilfisk to the customer, whether based on contract, negligence or otherwise with respect to, or arising out of such equipment. The remedies set forth herein are exclusive, and the inability of Nilfisk with respect to this sale or anything done in connection therewith, whether in contract, in tort, under any warranty, or otherwise, shall not, except as expressly provided herein, exceed the price of the equipment or part on which such liability is based. [. . . ] Correction of non-conformities or defects in the manner and for the period of time provided above, shall constitute fulfilment of all Inabilities of Nilfisk to the customer, whether based on contract, negligence or otherwise with respect to, or arising out of such equipment. The remedies set forth herein are exclusive, and the inability of Nilfisk with respect to this sale or anything done in connection therewith, whether in contract, in tort, under any warranty, or otherwise, shall not, except as expressly provided herein, exceed the price of the equipment or part on which such liability is based. This warranty does not cover repairs due to normal wear and tear, accident, neglect, misuse or abuse, incorrect installation or use other than as described in the instruction booklet. [. . . ]