User manual NILFISK IV-055

[. . . ] Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician. This appliance is for use on a nominal 120-volt circuit and has a grounding attachment plug that looks like the plug illustrated in figure A below. [. . . ] This machine is not suitable for picking up health endangering dust, unless all special authorised local/state federal precautions are complied with. This machine is for dry use only and shall not be used or stored outdoors in wet conditions. The machine must not be used for the suction of water or other liquids. Live conductors must not be vacuum cleaned by the machine for dry dust before their current has been switched off. This is to avoid creating a shortcircuit through the dust remaining in the nozzles and tubes. The machine must not be used for picking up combustible or explosive materials, nor should it be used in an explosive atmosphere. Under no circumstances should the machine be used for picking up hot material. In particular the machine must not be used for cleaning open and closed fireplaces, ovens or similar objects that contain warm or glowing ashes. Regularly inspect the cord and plug for damage, in particular if it has been crushed, shut in a door or run over. Always turn off this vacuum cleaner before connecting or disconnecting motorized nozzle. When repairing or replacing the cord, the same type of cord as originally supplied with the machine must be used. Apply soft pressure and turn the inlet sleeve approximately half a turn to ensure it is firmly secured. Adjustment of strap position on support plate: On the primary strap, the position of the strap can be adjusted for your individual comfort by moving the adjustment plate to the inner or outer position. Adjustment of tension ties on the strap's support plate: You can adjust the tension ties for your individual comfort. Form a loop with your finger, then move the tie through the clip forwards or backwards to the required length. Adjust the straps vertically by pulling down on both ties as shown in the picture. Cord set: This vacuum cleaner is equipped with a 50 ft extension power cord, of type 3x16AWG, 125V, SJT, SJO, that must be connected to the cord set from the machine. Place the end of the extension cord in to the snap hook from the vacuum cleaner in order to create a cord relieve by the hook. When cleaning is performed roll up the extension cord starting at the machine end and store it at the machine belt by snapping the nylon strap around the cord. Place the end of the extension cord in to the snap hook that is placed at the vacuum cleaner in order to create a Cord Relief by the hook. Dust bag: If the suction power diminishes, it may be time to replace the dust bag. Grasp at the cardboard part of the dust bag and carefully lift the bag out of the container. [. . . ] In that case, peel off the protective paper and fold the cardboard collar to seal the bag. Main filter: When you replace the dustbag also replace or clean the Main filter. Reinstall the filter into the machine or replace it with a new one if it can not be cleaned. When handling a new HEPA filter, avoid touching the surface of the filter. [. . . ]