User manual NILFISK GWD 350

[. . . ] Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. This appliance is not to be used by children or persons with reduced physical, sen-sory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. If the cleaner is not working properly or has been dropped, damaged, left outdoors, or dropped into water, return it to a service center or dealer. Use only as described in this manual and only with the manufacturer's recommended attachments. [. . . ] Detach the drain hose from the bracket by pulling hose backwards from the cleaner. Place the drain hose end near a floor drain and then remove the plug at hose end. 2g) Emptying from the container: Pull the upper parts of the latches outwards and release the motor top. to avoid movement of the trolley - place one foot at the basepart of the trolley. Then tilt the container backwards and pour the liquids into a floor drain or similar. Make sure that the switch/ switches is located in direction towards the suction inlet. Then connect the suction hose into the suction inlet at the machine by pushing the hose forward until it snaps in place at the inlet (to release the hose from machine just push the release button downwards and then pull out the hose). Then connect the two tubes with the hose handle, twist the tubes in order to ensure that they are properly fitted. Choose nozzle depending on what type of material that is to be picked-up. Put the electrical switch into position 1 in order to start the motor. Some variants have two motors/fan units and two electrical switches - one switch for each motor. Then adjust the handle by moving it upwards or downwards until the proper angle is found. Tighten the both locking screws again to secure the handle The machine is equipped with a float body that shuts of the airflow through the machine when the maximum liquid level is reached. You will then hear a noticeable change of the sound from the motor and notice that the suction power decreases. Release the latches by pulling them outwards so that the motor top is released. Cartridge filter: To clean the filter you can either shake, brush or wash it. The new bag is fitted by passing the carboard piece with the rubber membrane through the vacuum inlet. make sure that the rubber membrane is passing past the heightening at the vacuum inlet. Make sure that the switch/switches is located in direction towards the suction inlet. Never pick up dry material without sackfilter or dustbag fitted in the machine. [. . . ] In particular, electrical tests for earth continuity, insulation resistance, and condition of the flexible cord should be checked frequently. In the event of any defect, the machine MUST be withdrawn from service, completely checked and repaired. Trained Service Engineers will be pleased to carry out on site servicing on a regular or as requested basis, to ensure the continuing safety and efficiency of your machine. Replacement fuse covers are available at any electrical retail outlet. [. . . ]