User manual NILFISK GM 80 CR

[. . . ] This Nilfisk machine is safe to use with fine powders or hazardous materials, as long as certain precautions are taken. Proper care of this cleaner is essential to the maintenance of its ultrafine filtering capabilities. BEFORE USE: DO NOT ATTEMPT TO OPERATE THIS CLEANER UNTIL YOU HAVE INSTALLED ITS VARIOUS COMPONENTS ACCORDING TO THE FOLLOWING INSTRUCTIONS: WARRANTY The Nilfisk companies warrant that Nilfisk equipment will be free of defects in workmanship or material for a period of two years from the date of delivery. [. . . ] Once it is inserted, rotate the inlet coupler a quarter turn to lock it into place. Either of the straight 22 inch stainless steel wands can be fitted to the other end of the hose by snapping it in place. You can connect the floor nozzle or the upholstery nozzle to the end of the straight wand. The GM 80CR kit includes a conductive crevice nozzle and conductive 3 inch round brush, which can be attached to either the wands or to the curved steel tube at the end of the conductive plastic hose. A tool caddy (#01720600) is also included to provide easy onboard storage of accessories. EMPTYING: IF THIS VACUUM CLEANER IS USED TO COLLECT HAZARDOUS MATERIAL, DO NOT ATTEMPT TO OPEN OR EMPTY ITS CONTENTS WITHOUT PERSONAL PROTECTIVE CLOTHING AND RESPIRATORY PROTECTION. Photo 4 To empty the container and its contents, first turn off the motor. Allow the cleaner to sit undisturbed for at least thirty (30) seconds. This will prevent ultrafine particles which are still suspended in the air inside the container from escaping into the work place. Then seal off the polyliner with the paper bag inside and install a new polyliner and paper bag according to step 2, Machine Setup. 4 DISPOSAL: Depending on local regulations, and the composition of the material you have collected, there can be a requirement for special handling and labeling of the filled and sealed plastic bags. Consult your local Occupational Safety and Health Administration (OSHA) and Environmental Protection Agency (EPA) official for details. MAINTENANCE Routine Maintenance: To ensure maximum performance of your Nilfisk vacuum cleaner, be sure to check your main filter regularly, possibly each time you change the paper bag. Your filter may need to be shaken to remove caked dust from time to time. Filter Replacement: To ensure that your Nilfisk vacuum cleaner delivers the years of trouble-free operation for which it was designed, it is necessary to check and replace filters regularly. Photo 5 1. Main Filter: The large napped cotton bag which is semipermanently mounted inside the container (photo 5) will not require frequent replacement. [. . . ] Make sure the power cord is properly fastened to the motor head, and it is properly plugged into the socket. If the circuit is functioning properly, but there is still no power, contact NilfiskAdvance America's Customer Service Department at (800) 645-3475, extension 2. Loss of Suction: If the GM 80 loses suction power during operation, there may be several reasons, the most likely of which is a full container. [. . . ]