User manual NILFISK GDS 2000

[. . . ] Cables on drums should always be completely unwinded to prevent the cable from overheating. 3 Extension cables should be of a watertight construction and comply with the below-mentioned requirements for length and cable dimensions. 1. 0 mm² 1. 5 mm² 2. 5 mm² max. 12. 5 m 20 m 30 m Water connection Connection to the public mains according to regulations. This high pressure washer is only allowed to be connected with the drinking water mains, when an appropriate backflow preventer has been installed, Type BA according to EN 1717. [. . . ] Mount the high pressure hose on the outlet (3). 6 4. 2 Mounting of spray lance and Click & Clean nozzles 1. Push the spray lance (6) into the spray gun (7) and screw it on. 2. Warning: When attaching the Click & Clean nozzles, the pawl on the side of the spray lance should come out again. Note: The Tornado® PR nozzle and the foam sprayer feature a swivel lock, which must be positioned in the hole in the Click & Clean spray lance. Press the pawl to detach the Click & Clean nozzle. Note: The spray lance (6) has a built-in low pressure nozzle that can be used for flushing away dirt. 4. 3 Water connection An ordinary 1/2" garden hose of min. Let the water run through the water hose before connecting it to the machine to prevent sand and dirt from penetrating the machine. Note: Check that the filter is fitted in the water inlet pipe and that it is not clogged up. Connect the water hose to the water supply by means of the quick connector (inlet water, max. Turn on the water. NOTE: Connection to the public mains according to regulations. 7 4. 4 Telescopic handle The machine features a telescopic handle. To raise or lower the handle, press the knob and move the handle upwards or downwards. When a click is heard, the handle is in right position. 4. 5 Start and stop of the machine (when connected to a water supply) The spray lance is affected by a thrust during operation - therefore always hold it firmly with both hands. Use the brush for removal of traffic film which is not removed by the nozzle. Attach the undercarriage nozzle and clean undercarriage and wheel arches. Remove water from the surface of the car with the scraper on the car brush. On surfaces with moss or algae you may start by applying Stone & Wood Cleaner with the foam sprayer. Another more effective and quicker method is to use the Patio Cleaner. Same method as for flagstones, but be careful - bad joints and wood may be damaged by high pressure. Adjust the distance (pressure) to the quality of the joints and the wood. Should the machine by mistake be frozen, it will be necessary to check it for damage. Frost damages are not covered by the guarantee! 6. 2 Winding up of electric cable and high pressure hose To avoid accidents, the electric cable and the high pressure hose should always be winded carefully up. The high pressure washer comes in two models: A) with hook for storage of high pressure hose (14) - B) with a hose reel (13). 6. 3 Storage of accessories f d b a+f a e c The standard accessories (spray gun (f), spray lance (a), nozzles (b) foam sprayer (c)) can be stored on the pressure washer. The nozzle cleaning tool (d) and a Click & Clean brush (e) can also be stored on the product. 12 7 Maintenance WARNING! [. . . ] that repair has not been carried out or attempted by other than Nilfisk-trained service staff. that the product has not been exposed to abuse such as knocks, bumps or frost. that only water without any impurities has been used. that the high pressure washer has not been used for rental nor used commercially in any other way. Repairs under this guarantee include replacement of defective parts, exclusive of packing and postage/carriage. [. . . ]