User manual NILFISK GD 930S2

[. . . ] This vacuum cleaner is designed to be safe when used to for cleaning functions as specified. Should damage occur to electrical or mechanical parts, the cleaner and / or accessory should be repaired by the manufacturer or competent service station before use in order to avoid further damage to the machine or physical injury to the user. â· Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. â· Keep hair, loose clothing, fingers and all parts of the body away from openings and moving parts. [. . . ] The GD 930/S2 is equipped with a specially designed cable, which if damaged, must be replaced by a cable of the same type. These cables are avaible at authorized service shops and must be installed by trained personnel. The GD 930/S2 is equipped with a thermal cut-out to protect the motor and other vital machine parts from overheating. Should the machine cut out, you will have to wait at least 5-10 minutes for it to automatically reset. While you are waiting, switch the machine off and unplug it, then check the hose, dust bag and filters to be sure that nothing is blocking the flow of air through the machine. A-b)Combination nozzle Adjust the nozzle according to the requirements of the floor you are cleaning. D)Crevice nozzle Use to clean furniture, radiators and others hard-to-reach places. E)Small combi-nozzle: The small combi-nozzle combines a dusting brush for furniture, picture frames, mouldings etc. With a fold-out nozzle for cleaning curtains, furniture and other soft surfaces. The suction control in the hose handle lets you regulate the air-flow to prevent the nozzles from fastening to the surfaces you are vacuum cleaning. Remove the plug from the socket before performing service or maintenance. The symbol on the product or on its packing indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. GD 930/S2 are designed, developed and rigorously tested to function efficiently and safely when properly maintained and used in accordance with the following instructions. These instructions have been prepared with safety and efficiency paramount. The MACHINE OPERATOR must be trained by a suitably qualified instructor, and be made aware of the relevant regulations and legislation currently in force at the time of use. CAUTION - This machine MUST NOT be used in explosive or inflammable atmospheres or where such atmospheres are likely to be produced by the presence of volatile liquid or inflammable gas or vapour. CAUTION - In no circumstances should the power supply cord be wrapped around fingers or any part of the operators person. CAUTION - The electrical supply plug must not be subjected to undue stress by pulling on the power supply cord. Your MACHINE must only be connected to an electrical supply of the same voltage and frequency as indicated on the rating plate. [. . . ] If it is necessary to fit a plug, the wires in this power supply cord are coloured in accordance with the following code: To connect the new plug: The wire which is coloured green & yellow must be connected to the terminal in the plug which is marked with the letter 'E' or by the safety earth symbol or coloured green or green & yellow. The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter 'N' or is coloured black or blue. The wire which is coloured brown must be connected to the terminal in the plug which is marked with the letter 'L' or is coloured red or brown. If the plug to be fitted does not conform to the above notation then consult a qualified electrician. [. . . ]