User manual NILFISK FLOORTEC 560 P

[. . . ] www. nilfisk-alto. com FLOORTEC 560 P DEUTSCH FRANÇAIS ENGLISH NEDERLANDS BETRIEBSANLEITUNG MANUEL D'UTILISATION USER MANUAL GEBRUIKSAANWIJZING B 3 2 3 3 D E 1 S310027 S310028 3 S310072 F G C 2 17 5 24 8 18 19 22 27 26 29 2 31 S310029 S310030 1 3 H I 16 6 11 10 15 23 13 5 2 4 9 30 28 6 12 20 S310074 S310032 J K 8 25 7 14 21 S310088 S310075 S310034 USER MANUAL ENGLISH INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 MANUAL PURPOSE AND CONTENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 TARGET . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 HOW TO KEEP THIS MANUAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Accelerator lever (adjusted by the Manufacturer: do not tamper with it nor use it to change the engine speed!) 13. Air lever (starter) ENGLISH TECHNICAL DATA Dimensions Cleaning width without side broom Cleaning width, with side broom Minimum machine length Machine width, without side broom Height when the handlebar is lowered Minimum height from ground Handlebar height, minimum/maximum Main broom size Side broom size Speed with maximum push force Maximum slope Hopper capacity Machine total weight Front wheel, steering Rear wheels, driving Sound pressure level (LpA) Petrol engine Make Model Values 600 mm 791 mm 1, 070 mm 773 mm 836 mm 40 mm 824/1, 120 mm 265 mm x 600 mm 420 mm 4. 4 Km/h 2% 50 L 105 Kg 125/37. 5-50 mm 250 x 50 mm 77 dB(A) Data Honda GX100 NOTE For other petrol engine data/values, see User's Manual. Dust vacuuming and filtering Paper dust filter 5-10 µm Main broom compartment vacuum Values 2 m2 12 mm H2O Diagrams Wiring diagram (see Fig. X) FR: engine frame K1: engine on/off switch SP: engine ignition coil SW1: hood safety switch Color code RD: Red BK: Black 146 2592 000(1)2005-03 A FLOORTEC 560 P 5 ENGLISH USER MANUAL STARTING AND STOPPING THE MACHINE Starting the machine 1. C). NOTE Do not use the starter lever if the engine is hot and if the air temperature is sufficiently high. C) handle until a certain resistance is achieved; then pull strongly and start the engine. C) handle to go back with strength but bring it back to its position to prevent the engine from being damaged. The engine cannot be started by means of the pull-starter cord handle (27, Fig. NOTE The engine running, the main broom always rotates, while the side broom doesn't move if it is lifted. ACCESSORIES/OPTIONS In addiction to the standard components, the machine can be equipped with the following accessories/options, according to the machine specific use: ­ main and side brooms with harder or softer bristles ­ Antistatic polyester or polyester BIA C dust filter ­ front wheel with brake pedal For further information concerning the optional accessories, contact Your Retailer. USE WARNING!On some points of the machine there are some adhesives indicating: ­ DANGER ­ WARNING ­ CAUTION ­ NOTE While reading this Manual, the Operator must pay particular attention to these symbols. Do not cover these adhesives for any reason, in case of damage replace them immediately. BEFORE START-UP 1. T). 6 FLOORTEC 560 P 146 2592 000(1)2005-03 A USER MANUAL 7. After about 5 seconds the engine runs, disengage the air lever (starter) (1, Fig. C), disengage the handle (10) from its retainer (11) and lower the handle (without turning it). The speed is proportional to the pressure applied to the selector lever (3, Fig. 9. NOTE When the dust filter is obstructed and/or the hopper is full, the machine cannot collect dust and debris anymore. NOTE When the hopper is full the machine cannot collect dust and debris anymore. The petrol engine has a warning system to prevent damages to the engine provoked by an insufficient quantity of oil in the carter. Before the carter oil level goes below the safety limit, the oil warning system automatically stops the engine. Stopping the machine 1. Avoid stopping for a long time with the machine in the same position and the brooms rotating: this could create unwanted marks on the floor. To collect light and bulky waste materials, lift the front skirt by pulling the lever (31, Fig. C); do not keep pushing onto the lever for a long time in order not to reduce the suction capability of the machine). For the machine to sweep properly the dust filter must be as clean as possible. [. . . ] R) rotates upward of 90° (as shown in figure); release the lever and check that the skirt returns to the initial position and does not stay in an intermediate one. If necessary, for the front skirt control cable adjustment or replacement, refer to the Service Manual. Install in the reverse order of removal. SKIRT HEIGHT AND OPERATION CHECK 1. Drive the machine on a level and adequate ground to check the skirt height. [. . . ]