User manual NILFISK ER 1600

[. . . ] This manual will help you get the most from your Nilfisk Rider Scrubber. Repairs, when required, should be performed by your Authorized Nilfisk Service Center, who employs factory trained service personnel, and maintains an inventory of Nilfisk original replacement parts and accessories. Please specify the Model and Serial Number when discussing your machine. The Model Number and Serial Number of your machine are shown on the Nameplate on the machine. [. . . ] The speed of the machine will increase as the pedal is pushed closer to the floor. Engine Speed Switch (51): There are three engine speed settings that can be selected by the engine speed switch (51) on the control panel. Use only for heavy engine load situations such as heavy scrubbing on inclines. To select between Idle and Run press and release the engine speed switch. The ER 1300 / 1600 has an automatic idle feature that will reduce the engine speed to idle when the foot pedal (29) has been in the neutral position for 20 seconds or more. The selected engine speed will automatically resume when the foot pedal is moved from neutral. If the engine speed switch (51) is pressed while in idle-override, the automatic idle feature will be temporarily disabled until the next time the foot pedal is moved from the neutral position. This can be useful during troubleshooting or if it is desired to let the machine run at full speed for warming up. SERVICE NOTE: Remove the detergent cartridge from the detergent box prior to filling to avoid spilling detergent on the machine. It is recommended that a separate cartridge be used for each detergent you plan to use. The detergent cartridges have a white decal on them so you can write the detergent name on each cartridge to avoid mixing them up. When installing a new cartridge, remove the Cap (A) and place the cartridge in the detergent box. The system should be purged of previous detergent when switching to a different detergent. SERVICE NOTE: Move machine over floor drain before purging because a small amount of detergent will be dispensed in the process. 3 Press and hold the detergent switch (61) for approximately 2 seconds. Release the switch when the chemical purge icon (E) appears on the display and the indicator on the detergent switch (61) starts flashing. 3 Press and hold the detergent switch (61) for approximately 2 seconds. Release the switch when the chemical purge icon (E) appears on the display and the indicator on the detergent switch (61) starts flashing. When the detergent level is nearing the bottom of this slot it is time to refill or replace the cartridge(s). Detergent Ratio (SCRUB SYSTEM MUST BE ON): The detergent mixture rate may be adjusted by pressing and holding the detergent switch (61) for two seconds. While the light is flashing, pressing and releasing the detergent switch will select the next detergent mixture. Once the desired mix is selected the detergent system will return to normal operation within three seconds. [. . . ] 5 Install the blade, following the steps in reverse order and adjust the squeegee tilt. SERVICE NOTE: Depending on the position of the Squeegee Mount Wrenches (40), you may not be able to rotate the wrench far enough to loosen or tighten depending on which you are trying to do. In this case, simply lift UP on the Handle (C) and rotate the wrench in the direction necessary to acquire adequate turning space and then allow the wrench to drop back DOWN into place on the hex. Adjusting the Squeegee Angle Adjust the squeegee angle whenever a blade is reversed or replaced, or if the squeegee is not wiping the floor dry. [. . . ]