User manual NILFISK E140.3-9 PAD X-TRA

[. . . ] Pour reprendre le travail après l'arrêt de la brosse / plateau support disque à cause de la surcharge, il est nécessaire d'arrêter la machine, en portant les interrupteurs de brosse / plateau support disque et du système d'aspiration (65 et 66) en position "0". Enlever la brosse / plateau support disque comme suit : · Avec la brosse / plateau support disque soulevé, porter l'interrupteur de brosse / plateau support disque (65) sur "I" et, après quelques secondes, le porter à nouveau sur "0" en détachant ainsi la brosse / plateau. The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal. [. . . ] ­ Do not tamper with the machine safety guards and follow the ordinary maintenance instructions scrupulously. Always keep the openings free from dust, hairs and any other foreign material which could reduce the air flow. ­ Pay attention during machine transportation when temperature is below freezing point. The water in the recovery tank or in the hoses could freeze and seriously damage the machine. ­ Use brushes and pads supplied with the machine and those specified in the User Manual. In case of machine malfunctions , ensure that these are not due to lack of maintenance. Otherwise, request assistance from the authorised personnel or from an authorised Service Center. ­ If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer. ­ To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of this Manual, must be performed by the authorised personnel or by an authorised Service Center. ­ Carefully read all the instructions before performing any maintenance/repair procedure. ­ Do not wash the machine with direct or pressurised water jets, or with corrosive substances. The overload is shown by the three warning lights (62, 63, 64) flashing simultaneously. To start scrubbing again after a brush/pad-holder stop due to overload, stop the machine by turning the brush/ pad-holder switch and the vacuum system switch (65 and 66) to "0". Turn on the machine by turning the brush/ pad-holder switch and the vacuum system switch (65 and 66) to "I". Until the green warning light (62) stays on, the batteries allow the machine to work normally. When the green warning light (62) turns off and the yellow (63) and red (64) warning lights turn on in sequence, it is necessary to charge the battery as the machine residual autonomy is at the minimum level. Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life. The machine speed varies according to the type of floor to be cleaned and the choice of using the brush or the pad. If necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter. Grasp the handlebar (2) and slightly lower it until the rear wheel (7) comes into contact with the floor (Fig. While holding the machine in this position, drive it to the transport/parking area. In order not to drag the brush/pad on the floor and leave wet marks, when finishing working, remove the brush/pad-holder from the deck by using the release device (see the procedure in After Using The Machine paragraph), then place it on the support (43). [. . . ] When assembling the new gasket, install the joint (F) in the rear central area, as shown in the figure. NOTE The hole (33), allowing to compensate the air in the cover air gap, contributes to create vacuum in the tank. NOTE The filter strainer (B) must be correctly positioned on the housing (D) of the support (C). NOTE The machine speed varies according to the type of floor to be cleaned and the choice of using the brush or the pad. [. . . ]