User manual NILFISK E 130.2

[. . . ] The operator and anyone in the immediate vicinity of the site of cleaning should take action to protect themselves from being struck by debris dislodged during operation. Wear goggles during operation. Never use the machine in an environment where there could be a danger of explosion. It is not allowed to clean asbestos-containing surfaces with high pressure. This high pressure washer must not be used at temperatures below 0°C. [. . . ] Note: If the machine is left or not used for 5 minutes, it must be switched off on the start/stop switch "O" (1): 1. Shut off the water supply and activate the trigger to relieve the machine of pressure. When releasing the trigger of the spray gun, the machine automatically stops. The machine will start again when you re-activate the spray gun. 4. 6 Start the machine (when connected to open containers (suction mode)) The washer can take in water from a rain water tank as an example. Make sure that the water tank is not placed on a lower level than the machine. Place the other end of the water hose in the water tank. Use an external filter if the water contains impurities. Activate the trigger of the spray gun and let the water run, until the air has escaped from the water hose and the pump. Mount spray lance and nozzle. 8 4. 7 Pressure regulation on the TORNADO® PRnozzle The pressure can be regulated on the TORNADO® PR nozzle. High pressure Low pressure 4. 8 Stationary use If mounting a special wall hook (not standard), the pressure washer can be used as a stationary solution meaning that it can be operated while hanging on the wall. Adjust the length of the screws and size of rawlplugs to the type of wall. On the wall hook garden/rim brush (a) foam sprayer (b), Click & Clean brush (c) and Click & Clean nozzles (d) can be stored. 30 kg. 9 5 Fields of application and working methods 5. 1 General Efficient high presure cleaning is achieved by following a few guidelines, combined with your own personal experience of specific cleaning tasks. Accessories and detergents, when correctly chosen, can increase the efficiency of your pressure washer. Here is some basic information about cleaning. 5. 1. 1 Detergent and foam Foam or detergent should be applied onto dry surfaces so that the chemical product is in direct contact with the dirt. Detergents are applied from bottom to top, for example on a car bodywork, in order to avoid "super clean" areas, where the detergent collects in higher concentration and streams downwards. Let the detergent work for several minutes before rinsing but never let it dry on the surface being cleaned. Otherwise the surfac that has to be cleaned can be damaged. 5. 1. 2 Mechanical effect In order to break down tough layers of dirt, additional mechanical effect may be required. ½ m (to mark) into a tube or drain and activate the trigger of the spray handle. The nozzle opening turning backwards will pull the cleaner through the tube. The nozzle will break down the , , plug" and flush the dirt backwards. Mount the water/sand blasting equipment and rust and paint is efficiently and quickly removed. Beware not to damage the surface to be sandblasted. Cleaning Tube cleaner of drain pipes, outlets, down pipes etc. Rust, paint Water/sandblasting equipment Greenhouse Garden tools, lawn mover Tornado® PR nozzle Wash with high pressure and maybe a brush. [. . . ] com under "PRODUCT REGISTRATION". 15 9. 3 Accessories Only use original accessories. Click & Clean Car nozzle Click & Clean Undershassis nozzle Special nozzle for enameled surfaces. Integrated guide shoes. Click & Clean Multiangle adaptor Click & Clean Brushes Extension hose Underchassis spray lance Drain & Tube cleaner Adjusted in angles from 0° - 90° for better working posture and cleaning of hard to get at places as for instance barrels or the underside of the lawn mower. Available in more shapes. 7 m extension hose increasing the working range. [. . . ]