User manual NILFISK C 115.3

[. . . ] The operator and anyone in the immediate vicinity of the site of cleaning should take action to protect themselves from being struck by debris dislodged during operation. This appliance has been designed for use with cleaning agents supplied or recommended by the manufacturer. The use of other cleaning agents or chemicals may adversely affect the safety of the appliance. Disconnect from electrical power supply before carrying out user maintenance. [. . . ] Thermal sensor: A thermal sensor protects the motor against overloading. The machine will restart after a few minutes when the thermal sensor has cooled. 4 Nilfisk C 105. 5 / C 115. 3 2 Description 2. 1 Application This high-pressure washer has been developed for domestic use within: - Car, motorbike, boat, caravan, trailer, patio/drive/flagstones, woodwork, brickwork, barbecue, garden furniture, lawn mower Only use the high-pressure washer for purposes described in this manual. The safety precautions must be observed to prevent damage to the machine, the surface to be cleaned or severe personal injuries. EN 2. 2 Operation elements and model survey See illustration at the end of this manual. 1 2 3 4 5 6 7 8 Start/stop switch Water inlet with filter (2a) High pressure connection High pressure hose Electric cable Click & Clean spray lance Spray handle with lock (7a) Click & Clean Tornado nozzle (C 105. 5) 9 Click & Clean Tornado PR nozzle (C 115. 3) 10 Click & Clean Powerspeed nozzle 11 Foam sprayer 12 Nozzle cleaning tool 13 Lance and nozzle holder 14 Model tag 15 Holder for electric cable (C 115. 3) 16. We reserve the right to alter the specifications. 5 Nilfisk C 105. 5 / C 115. 3 EN 3 Before you start using your pressure washer 3. 1 Mounting of trolley handle (C 115. 3) 1. Note: The inlet filter (2a) must always be fitted in the water inlet pipe to filter out sand, limestone and other impurities as these will damage the pump valves. Caution: Failure to fit the filter will invalidate the guarantee. 3. 3 Mounting of high pressure hose on spray handle 1. Detach the high pressure hose by pressing the pawl (A). A 6 Nilfisk C 105. 5 / C 115. 3 4 Operating your pressure washer 4. 1 Connection of high pressure hose 1. Mount the high pressure hose on the outlet (3). EN 4. 2 Mounting of spray lance and Click & Clean nozzles 1. Note: The spray lance (6) has a built-in low pressure nozzle that can be used for flushing away dirt. 2. Warning: When attaching the Click & Clean nozzles, the pawl on the side of the spray lance (6) should come out again. Note: The foam sprayer (11) features a swivel lock, which must be positioned in the hole in the Click & Clean spray lance (6). Press the pawl to detach the Click & Clean nozzle. 7 Nilfisk C 105. 5 / C 115. 3 EN 4. 3 Water connection An ordinary 1/2" garden hose of min. NOTE: Connection to the public mains according to regulations. IMPORTANT!from your own well), an additional filter (106411231) should be mounted. Let the water run through the water hose before connecting it to the machine to prevent sand and dirt from penetrating the machine. Note: Check that the filter is fitted in the water inlet pipe and that it is not clogged up. Connect the water hose to the water supply by means of the quick connector (inlet water, max. Turn on the water. 4. 4 Start and stop of the machine The spray lance is affected by a thrust during operation - therefore always hold it firmly with both hands. Activate the trigger of the spray handle and let the water run until all air has escaped from the water hose. Always adjust the distance and thus the pressure of the nozzle to the surface, which is to be cleaned. Do not cover the machine during operation or use it in a room without adequate ventilation !Note: If the machine is left or not used for 5 minutes, it must be switched off on the start/stop switch "O" (1): 1. Shut off the water supply and activate the trigger to relieve the machine of pressure. When releasing the trigger of the spray handle, the machine automatically stops. [. . . ] that repair has not been carried out or attempted by other than Nilfisk-trained service staff. that the product has not been exposed to abuse such as knocks, bumps or frost. that only water without any impurities has been used. that the high pressure washer has not been used for rental nor used commercially in any other way. Repairs under this guarantee include replacement of defective parts, exclusive of packing and postage/carriage. [. . . ]