User manual NILFISK BDC1330

[. . . ] This vacuum cleaner is suitable for commercial use, in hotels, schools, hospitals, factories, shops, offices and apartment hotels for example, for hire and in any case for purposes other than normal domestic use. This vacuum cleaner was conceived to clean and collect solid non-flammable materials indoor and outdoor. WARNING ­ This vacuum cleaner can only be used to vacuum dry materials. Always leave enough room around the vacuum cleaner to reach the controls easily. [. . . ] Plug the vacuum cleaner into a socket with a correctly installed ground contact/connection. The plugs and connectors of the connection cables must be protected against splashes of water. Use the vacuum cleaners only when the cables that connect to the electrical mains are in perfect condition (damaged cables could lead to electric shocks!Regularly check there are no signs of damage, excessive wear, cracks or ageing on the electric cable. When the vacuum cleaner is operating, do not: Crush, pull, damage or tread on the cable that connects to the electrical mains. Only disconnect the cable from the electrical mains by removing the plug (do not pull the cable). Only replace the electric power cable with one of the same type as the original: H07 RN - F. The cable must be replaced by the manufacturer's Service Centre staff or by equivalent qualified personnel. Unpacking, moving, use and storage operate on flat , horizontal surfaces. The load-bearing capacity of the surface the vacuum cleaner is placed on must be suitable for bearing its weight. If an extension cable is used, make sure it is suitable for the power input and protection degree of the vacuum cleaner. Do not shake the filter while the vacuum cleaner is on, as this could damage the filter itself. Wait before restarting the vacuum cleaner, to allow the dust to settle. Class M vacuum cleaners are supplied with a paper dust bag - code 81584000 (Fig. Class M vacuum cleaners must always be used with this paper bag installed. If the paper bag is not installed or is installed incorrectly, this could create health risks for persons exposed. These operations can only be carried out by trained and qualified personnel who must wear adequate clothing, in compliance with the laws in force. When maintenance or repair procedure are carried out, all the contaminated elements that cannot be properly cleaned, must be eliminated. These elements must be disposed of in sealed bags in accordance with applicable regulations and local laws on the disposal of such material. This procedure must also be followed when the filters are eliminated (main, HEPA and downstream filters). Compartments that are not dust-tight must be opened with suitable tools (screwdrivers, wrenches, etc. Remove the bag making sure that the union tubular element is kept connected to the inlet. [. . . ] Close the cover hermetically by means of the lever (4) and lock the safety bolt (5) again. These operations can only be carried out by trained and qualified personnel Periodically clean the motor cooling fan to prevent the motor from overheating, especially if the vacuum cleaner is used in a dusty place. If the hoses are damaged, broken or badly connected to the unions, they must be replaced. When sticky materials are treated, check for possible clogging along the hose (3, Fig. [. . . ]