User manual NILFISK BA 340

[. . . ] GB The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. Specifications and details are subject to change without prior notice. When using an electrical appliance, basic precautions should always be followed, including the following. [. . . ] When disposing of old machines or machine components local or national regulations must be applied for their safe disposal. Repairs, when required, should be performed by Nilfisk service personnel using Nilfisk original replacement parts and accessories. Please specify the Model and Serial Number when discussing your machine. The Model and Serial Number of your machine are shown on the Name plate on the back panel of the machine. This information is needed when ordering repair parts for the machine. Use the space belows to note the Model and Serial Number of your machine for future reference. When the machine is delivered, carefully inspect the shipping carton and the machine for damage. If damage is evident, save the shipping carton so that it can be inspected by the carrier who delivered it. Nilfisk uses the symbols below to signal potentially dangerous conditions. Always read this information carefully and take the necessary steps to protect personnel and property. Is used to call attention to a situation that could cause severe personal injury. Is used to call attention to a situation that could cause minor personal injury or damage to the machine or other property. Display Handle bar Handle bar adjustment Rear grip position for transport Solution filter Tank top Solution tank (clean water) Recovery tank (dirty water) Front grip position for transport Squeegee head Spray nozzle Front squeegee Brush Rear squeegee Pre-filter vacuum motor Exhaust sound insulation Turbine pre-filter Battery container Charger connection Fuses Charging the batteries - charging control A deep discharge protection prevents batteries from being discharged too much. How it works: At low battery voltage, a red LED will flash: Pick up remaining water; After 2 minutes all motors will stop. Machine will work again after battery re-charge-red LED off LED off = Battery charged LED flashing = Batteries need to be re-charged LED on = Battery is being re-charged Re-charge batteries after every machine operation. Do not use naked flames or heat sources, electric arc or sparks near batteries. [. . . ] If the squeegee leaves narrow streaks of water, it is probably dirty or damaged. Motors do not work Defective switch on operating panel Check battery charge and connections Brush motor does not work, brush does not turn Defective drive belt Brush not fixed Worn or defective squeegees Clogged suction inlet Defective suction hose loose Inadequate suction Defective tank lid Jammed float valve Dirty turbine pre-filters Worn brush Too soft brush Poor cleaning Work at a lower speed Clogged water supply Clogged solution filter Model Rating of brush motor Rating of vacuum motor Rating of pump motor Protection grade Protection class (elect. Sound pressure level (at 1, 5 m) Working width of brush Productivity rate (theoretical) Solution control Solution tank Recovery tank Membrane tank Machine length Overall width w/squeegee Machine height w/handle Weight empty Operating weight Battery capacity pcs cm r. [. . . ]