User manual NILFISK B23 STAINLESS

[. . . ] This machine produces a water jet of a high temperature which is why severe injuries can occur if the safety precautions are not observed. A complete understanding of the contents of this instruction manual is required in order to prevent injuries to yourself and persons nearby, damage to objects and to the machine itself. Fields of applications The Nilfisk-ALTO B23 has been designed for the cleaning of small items in the workshop, in such a way as to minimize the number of moving parts and components. When in operation the Nilfisk-ALTO B23 is ideal for the effective cleaning of brake parts, couplings, ball bearings, valves, machinery parts and electrical motors. [. . . ] If you are in any doubt, please contact a qualified electrician or your nearest Nilfisk-ALTO distributor. We recommend that you connect the machine to a power source with a Residual Current Device (RCD), which will disconnect the power supply if the leakage current exceeds 30mA for 30 milli seconds. The electric supply connection shall be made by a qualified electrician and comply with the latest edition of the IEC Wiring Regulations. Note: If an extension cable is required it must be earthed and connected through the plug to the earth cable of your supply network in accordance with prescribed safety regulations. If you want to apply an extension cable, we recommend that you use the following cable dimensions: 3 x 1. Never direct the water jet towards people, pets, electric wiring, or the machine itself. Never open the pressure tank or detach the hose when the system is under pressure. Only use original Nilfisk-ALTO spare parts for repair and maintenance. Only Nilfisk-ALTO spare parts ensure that your washer is operational and reliable. Do not use the machine if the safety devices, electrical connections or the pressure tank are defective. Persons under the influence of alcohol, drugs and medicine should not operate the machine. When using detergents the enclosed instructions should always be strictly observed. Always unplug before you perform any cleaning or maintenance of the machine. Place the wash tray and the wash basket and secure the adjusting handle to the correct height. Attach the spray handle with the hose by screwing the hose onto the outlet at the top of the washer. Fill the tank with an adequate mixture of water and detergent until the liquid is visible from above (max. Screw on the cap and tighten it by hand - do not use a tool or overtighten. Start the washer with the switch (12) that is lit green, and set the temperature dial (11) to the required temperature. When the required temperature has been reached, the red indicator will go out and the thermostat will ensure that the temperature is kept constant. Disconnect the plug from the socket and wind the cable round the transport handle. [. . . ] 2 Allosil® Special product for water based degreasing and cleaning with hot or cold water. 1 Guarantee Our general conditions of business are applicable with regard to the guarantee. Unauthorised modifications to the appliance, the use of incorrect accessories, spare parts and cleaning chemicals in addition to using the appliance in a way other than for the intended purpose exempt the manufacturer from any liability for the resulting damage. To avoid unnecessary disappointments, you should check the following before contacting the nearest Nilfisk-ALTO service organisation: Cause · Check pressure in pressure tank Check nozzle in spray handle - nozzle clogged up? [. . . ]