User manual NILFISK ATTIX 140

[. . . ] Only versions with the level sensor can be used for liquids, if not, they can only be used to vacuum dry materials. If foam or liquid spills from the vacuum cleaner, switch it off immediately and check for the cause. The use of vacuum cleaner by people (including children) with limited physical and mental capacities or lacking in experience and knowledge is strictly forbidden, unless they are supervised by a person who is experienced in the use and safe handling of the machine. Children must be supervised to make sure they will not play with the machine. [. . . ] Regularly check that the electric cable does not show signs of damage excessive wear, cracks or ageing. When the vacuum cleaner is operating: Do not crush, pull, damage or tread on the cable that connects to the electrical mains. Only disconnect the cable from the electrical mains by removing the plug (do not pull the cable). Only replace the electric power cable with one of the same type as the original: HO7 RN - F. The cable must be replaced by the manufacturer's Service Centre staff or by equivalent qualified personnel. If an extension is used, make sure it is fit for the power draw and protection degree of the vacuum cleaner. The vacuum cleaner's power socket must be protected by a differential circuit-breaker with surge current limitation, that shuts off the power supply when the current dispersed towards ground exceeds 30 mA for 30 ms or an equivalent protection circuit. Never spray water on the vacuum cleaner: such action constitutes a danger hazard for persons and could short circuit the power supply. Consult the latest edition of the European Union Directives, the Laws in the country of use and the current standards in force (UNI - CEI - EN), particularly European standard EN60335-2-69. Comply with the safety regulations governing the materials for which the vacuum cleaner is used. If the version for liquids is used: Make sure that the liquid level sensor operates correctly before vacuuming liquids. If foam forms, stop the vacuum cleaner immediately and empty the container. Warning: Switch off the vacuum cleaner immediately if foam or liquid leaks out. Regularly clean the liquid level limiting device and check to make sure that there are no signs of damage. Warning: the dirty liquid collected by the vacuum cleaner must be considered conductive. Disconnect the vacuum cleaner from its power source before cleaning, servicing, replacing parts or converting it to obtain another variant, the plug must be removed from the socket. Failure to comply with these instructions could jeopardize your safety. Moreover, such action would immediately void the EC declaration of conformity issued with the vacuum cleaner. To carry out maintenance operations which are not described in this manual contact the manufacturer's Service Centre or our sales network. Figure 4 1 2 3 4 5 Container release lever Castor lever Manual filter shaker knob Start/stop switch (normal version) Start/stop switch (version for vacuuming liquids) Lock the castor brakes before starting the vacuum cleaner (1). Turn the switch to "0" position to turn the vacuum cleaner off. version for vacuuming liquids Turn the switch (3) to "I" position to start the vacuum cleaner. [. . . ] This inspection must be carried out by the manufacturer or by a competent person. Use only genuine spare parts supplied and authorized by the manufacturer. Before proceeding with these operations, turn off the vacuum cleaner and remove the plug from the power socket. Periodically clean the motor cooling fan to prevent the motor from overheating, especially if the vacuum cleaner is used in a dusty place. [. . . ]