User manual NILFISK ATTIX 155

[. . . ] When the vacuum inlet and/or hose are turned to parts of the human body. Use without the guards, protective covers and safety systems installed by the manufacturer. Explosive dust/substances and/or ones liable to ignite in a spontaneous way (such as magnesium or aluminium dusts, etc. Use the vacuum cleaner in accordance with the laws in force in the country where it is used. [. . . ] Comply with the safety regulations governing the materials for which the vacuum cleaner is used. If the version for liquids is used: Make sure the liquid level sensor is working correctly before vacuuming liquids. If foam forms, turn off the vacuum cleaner immediately and empty the container. Warning: Switch off the vacuum cleaner immediately if foam or liquid leaks out. Regularly clean the liquid level limiting device and check to make sure that there are no signs of damage. When vacuuming a mix of water and air, take care to avoid overloading the motor of the vacuum unit. If an extension cable is used, make sure it is suitable for the power input and protection degree of the vacuum cleaner. The vacuum cleaner's power socket must be protected by a differential circuit-breaker with surge current limitation, that shuts off the power supply when the current discharged to the ground exceeds 30 mA for 30 ms or an equivalent protection circuit. Never spray water on the vacuum cleaner: this could be dangerous for persons exposed and could short circuit the power supply. Comply with the safety regulations governing the materials for which the vacuum cleaner is used. Disconnect the vacuum cleaner from its power source before cleaning, servicing, replacing parts or converting it to obtain another version/variant, the plug must be removed from the socket. Failure to comply with these instructions could jeopardize your safety. Moreover, such action would immediately void the EC declaration of conformity issued with the vacuum cleaner. Depending on the vacuumed dust quantity and if the pointer of the vacuum gauge switches from the green zone (2) to the red zone (3) turn the vacuum cleaner off and shake the main filter with the knob (1). Do not shake the filter while the vacuum cleaner is on, as this could damage the filter itself. Wait before restarting the vacuum cleaner, to allow the dust to settle. All latches are tightly locked; The vacuum hose and tools have been correctly fitted into the inlet (1); The bag or safety container is installed, if applicable. Before proceeding with these operations, turn off the vacuum cleaner and remove the plug from the power socket. Before emptying the container it is advisable to clean the filter (see "Shaking the filter" paragraph). Dust/liquid container Release the container (1), then remove and empty it. Clean the grill inside the container to remove debris or solid residues which may prevent the liquid from draining properly. Turn the switch to "0" position to turn the vacuum cleaner off. [. . . ] Periodically clean the motor cooling fan to prevent the motor from overheating, especially if the vacuum cleaner is used in a dusty place. This product can not be disposed of together with other commercial waste. The following is a list of spare parts that should be kept ready at hand in order to speed up maintenance operations. Refer to the manufacturer's spare parts catalogue when ordering spare parts. [. . . ]