User manual NIKKO PT07910

[. . . ] The consumption indications on the data plate have been calculated for this type of installation. Secure the appliance to the cabinet by opening the oven door and putting 4 screws into the 4 holes of the outer frame. All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool. Ovens equipped with a three-pole power supply cable are designed to operate with alternating current at the voltage and frequency indicated on the data plate located on the appliance (see below). [. . . ] See the Cooking advice table for cooking modes and the suggested cooking temperatures (see Cooking Modes). When lit, the THERMOSTAT indicator light indicates that the oven is heating up to the temperature set. You may do the following during cooking: - change the cooking mode by turning the SELECTOR knob. Never put objects directly on the oven bottom to avoid damaging the enamel coating. A temperature value can be set for all cooking modes between 60°C and Max, except for • BARBECUE (recommended: set only to MAX power level); • GRATIN (recommended: do not exceed 200°C). TRADITIONAL OVEN mode Both the top and bottom heating elements will come on. With this traditional cooking mode, it is best to use one cooking rack only: if more than one rack is used, the heat will be distributed unevenly. MULTI-COOKING mode All the heating elements (top, bottom and circular), as well as the fan, will come on. Since the heat remains constant throughout the oven, the air cooks and browns food uniformly. bARBECUE mode The top heating element and the rotisserie (where present) come on. The high and direct temperature of the grill is recommended for food that requires high surface temperature. Next, press the button until the icon and the four digits on the DISPLAY begin to flash. Use the “+” and “-” buttons to adjust the cooking end time; if you press and hold either button, the display will scroll through the values more quickly, making it quicker and easier to set the desired value. Wait for 10 seconds or press the button again to finalise the setting. When the set time has elapsed, the text END appears on the DISPLAY, the oven will stop cooking and a buzzer sounds. The DISPLAY shows the cooking end time and the cooking duration alternately. Cancelling a programme To cancel a programme: • press the button until the icon corresponding to the setting you wish to cancel and the digits on the display are no longer flashing. • Press and hold the “+” and “-” buttons; this will cancel all the settings selected previously, including timer settings. INCREASE TIME button Setting the clock  The clock may be set when the oven is switched off or when it is switched on, provided that a the end time of a cooking cycle has not been programmed previously. After the appliance has been connected to the mains, or after a blackout, the icon and the four numerical digits on the DISPLAY will begin to flash. It is extremely dangerous to leave the appliance exposed to rain and storms. • When handling the appliance, always use the handles provided on the sides of the oven. [. . . ] If the seals are damaged, please contact your nearest After-sales Service Centre (see Assistance). GB Cleaning the appliance  Never use steam cleaners or pressure cleaners on the appliance. • The stainless-steel or enamel-coated external parts as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. If these stains are difficult to remove, use only specialised products. [. . . ]