User manual NETGEAR WNDAP620

[. . . ] After installing your device, locate the serial number on the label of your product and use it to register your product at https://my. You must register your product before you can use NETGEAR telephone support. NETGEAR recommends registering your product through the NETGEAR website. Phone (Other Countries): Check the list of phone numbers at http://support. [. . . ] To update the display onscreen, click Refresh; to clear the log content, click Clear. The following table explains the fields of the Statistics screen: Table 21. Statistics fields Setting Wired Ethernet Packets The number of packets received and transmitted over the Ethernet connection since the wireless access point was restarted. The number of bytes received and transmitted over the Ethernet connection since the wireless access point was restarted. 11na Note: The section heading depends on the configured wireless mode. Unicast Packets The number of unicast packets received and transmitted over the wireless connection since the wireless access point was restarted. management and Monitoring 84 ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620 Table 21. Statistics fields (continued) Setting Broadcast Packets Description The number of broadcast packets received and transmitted over the wireless connection since the wireless access point was restarted. The number of multicast packets received and transmitted over the wireless connection since the wireless access point was restarted. The total number of packets received and transmitted over the wireless connection since the wireless access point was restarted. The total number of bytes received and transmitted over the wireless connection since the wireless access point was restarted. 11a Radio The number of associated clients connected to the radio in the configured wireless modes. Enable Rogue AP Detection and Monitor Access Points • • Enable and Configure Rogue AP Detection View and Save Access Point Lists Enable and Configure Rogue AP Detection The wireless access point can detect rogue access points and prevent them from connecting to the wireless access point. The wireless access point maintains a list of access points it detects in the area. Initially all detected access points are displayed in the Unknown AP List. You restrict communication to approved access points by adding them to the Known AP List and enabling the rogue AP detection feature. If you enable rogue AP detection, the wireless access point continuously scans the wireless network and collects information about all access points on its channel. (The following figure shows examples in the Known AP List and Unknown AP List. Select the Turn Rogue AP Detection On check box to enable rogue AP detection. Specify the detection policy by making a selection from the Rogue AP Detection Policy drop-down list: • Mild. The wireless access point scans for rogue access points every 10 seconds. The wireless access point scans for rogue access points every 5 seconds. [. . . ] This radio transmitter (IC: 4054A-12200202 / Model: WNDAP620) has been approved by Industry Canada to operate with the antenna type, maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this user's manual, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Conformement a la reglementation d'Industrie Canada, le present emetteur radio peutfonctionner avec une antenne d'un type et d'un gain maximal (ou inferieur) approuve pourl'emetteur par Industrie Canada. Le present emetteur radio (IC: 4054A-12200202 / Model: WNDAP620) a ete approuve par Industrie Canada pour fonctionner avec les types d'antenne enumeres ci-dessous et ayant un gain admissible maximal et l'impedance requise pour chaque type d'antenne. [. . . ]