User manual NETGEAR WMS5316

[. . . ] No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of NETGEAR, Inc. To register your product, get the latest product updates, or get support online, visit us at http://support. Trademarks NETGEAR, the NETGEAR logo, ReadyNAS, ProSafe, Smart Wizard, and Auto Uplink are trademarks or registered trademarks of NETGEAR, Inc. microsoft , Windows , Windows NT , and Vista are registered trademarks of Microsoft Corporation. [. . . ] chapter 4: Security Configuration | 29 ProSafe 16 AP Wireless Management System WMS5316 Reference Manual Note: Most networks do not require access point groups. See Chapter 1, Getting Started for more information about basic settings and advanced settings for access point groups. To set up MAC authentication for only the selected access point group: 1. Click a group tab to select the access point group that will use access control. Select the Turn Access Control On check box if you want the access point to interact only with stations present in the Trusted Wireless Stations list. Select one of the following databases: • Local MAC Address Database: The access point will use the local MAC address table for Access Control. € Remote MAC Address Database: The access point will use the MAC address table located on an external RADIUS server on the LAN for access control. Make sure that the correct wireless stations are in the Trusted Wireless Stations list. If you are using access control, only these stations will be allowed access to the network through this access point. - To remove a wireless station from this table , select it and click Delete. To add a wireless station to this table, enter its MAC address and click Add. To move a wireless station from the Available Wireless Stations list to the Trusted Wireless Stations list, select it, and click Move. 30 | Chapter 4: Security Configuration ProSafe 16 AP Wireless Management System WMS5316 Reference Manual Radius Server Settings If you are using a RADIUS server in your network for authentication, you must configure Radius settings. You can configure four types of servers: • • • • Primary Authentication Server: The primary authentication server is the main RADIUS server used for authentication. Secondary Authentication Server: A secondary authentication server can be configured for use if the primary authentication server fails or is unreachable. Primary Accounting Server: The primary accounting server is used for accounting on the network. Secondary Accounting Server: A secondary accounting server can be configured for use if the primary authentication server fails or is unreachable. Click the Configuration tab and select Security > Basic > Radius Server: The primary server is used by default. If the primary server fails, the secondary server is used, if configured. Fill in the IP Address, Port, and Shared Secret fields for each RADIUS server. • The IP Address , Port , and Shared Secret information is required to communicate with the RADIUS server. € The shared secret is shared between the wireless access point and the RADIUS server while the server is authenticating the wireless client. [. . . ] The Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right to test the series for compliance with the regulations. FCC Caution • Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Regulatory Compliance Information This section includes user requirements for operating this product in accordance with National laws for usage of radio spectrum and operation of radio devices. [. . . ]