User manual NETGEAR WGR614V5 INSTALLATION GUIDE

[. . . ] f. 54 Mbps Wireless Router WGR614 Broadband modem Power Test Wireless Internet Port LAN Port 4 d. Check the status lights and verify the following: · Power: The power light should turn solid green. When you first turn on the router, the power light blinks during its self test, then turns solid green. Test: The test light blinks when the router is first turned on then goes off. [. . . ] It should be set to obtain both IP and DNS server addresses automatically, which is usually so. For help with this, please see the Reference Manual or animated tutorials on the Resource CD. Your network cables are connected and you are ready to restart your network. 2 Restart Your Network in the Correct Sequence Warning: Failure to restart your network in the correct sequence could prevent you from connecting to the Internet. Cable 1 a. First, turn on your broadband modem and wait 2 minutes. Note: For DSL customers, if software logs you in to the Internet, do not run that software. You may need to go to the Internet Explorer Tools menu, Internet Options, Connections tab page where you can select "Never dial a connection. " d. A b. Enable your wireless network, click Next to proceed, then click Done to finish. Wireless Feature Network Name (SSID) WEP Security Default Setting NETGEAR Disabled Make sure the network settings of the computer are correct · Ethernet cable and wirelessly connected computers must be configured to obtain IP and DNS addresses automatically via DHCP. For help with this, please see the animated tutorials on the Resource CD or the Reference Manual Appendix C on the Resource CD. Some cable modem ISPs require you to use the MAC address of the computer registered on the account. If so, in the Router MAC Address section of the Basic Settings menu, select, "Use this Computer's MAC Address. " The router will then capture and use the MAC address of the computer that you are now using. Restart the network in the correct sequence. Note: The router Smart Wizard configuration assistant only appears when the router is in its factory default state. You can always connect to the router configuration menu to change its settings. Then, when prompted, enter admin as the user name and password for the password, both in lower case letters. Warning: The Network Name (SSID) is case sensitive. Entering nETgear will not work. · 2 Verify Wireless Connectivity with a wireless adapter. You are now Connect to the Internet from a computer wirelessly connected to the Internet!Important: Implement wireless security options appropriate to your needs. These settings enable basic wireless connectivity that let you can set up your wireless computers and test wireless Internet access through the router. Please read the NETGEAR manual to identify the wireless security features of your router that satisfy your requirements and work with your wireless computer. · · Check the router status lights to verify correct router operation If the Power light does not turn solid green within 2 minutes after turning the router on, reset the router according to the instructions in the Reference Manual on the Resource CD. If the Wireless light does not come on, verify that the wireless feature is turned on according to the instructions in the Reference Manual on the Resource CD. Documentation 4 Netgear Product Registration, Support, andregister your product at After completing the Smart Wizard configuration assistant, http://www. NETGEAR. com/register. [. . . ] In France, the equipment must be restricted to 2. 44654 ~ 2. 4835 GHz frequency range and must be restricted to indoor use. ©2004 NETGEAR, Inc. NETGEAR, the Netgear logo, Auto Uplink, ProSafe and Everybody's connecting are trademarks or registered trademarks of Netgear, Inc. Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States and/or other countries. [. . . ]