User manual NETGEAR RP614V2 INSTALLATION GUIDE

[. . . ] c. Installation Guide Securely insert the Ethernet cable from your cable or DSL modem into the Internet port (B) on the RP614. Internet Port Start Here Follow these instructions to set up your router. B Power Test Internet Port LAN Port 4 d. Web Safe Router RP614 Cable or DSL modem Check the status lights and verify the following: · · · Power: The power light is on. [. . . ] Note: If software usually logs you in to the Internet, do not run that software or cancel it if it starts automatically. c. d. Enter admin for the router user name and password for the router password, both in lower case letters. After logging in to the router, you will see the Internet Connection Setup Wizard on the settings main page. Cable or DSL modem 4 Run the Setup Wizard to Connect to the Internet Troubleshooting Tips Here are some tips for correcting simple problems that prevent you from connecting to the Internet or connecting to the router. Technical Support PLEASE REFER TO THE SUPPORT INFORMATION CARD THAT SHIPPED WITH YOUR PRODUCT. By registering your product at www. NETGEAR. com/register, we can provide you with faster expert technical support and timely notices of product and software upgrades. Be sure to restart your network in the correct sequence · Follow this sequence. Next turn on the router, and finally the computer. Make sure the Ethernet cables are securely plugged in · a. If you do not see this menu, click the Setup Wizard link on the upper left of the main menu. Input your ISP settings, as needed and click Apply to save your settings. Click Test to verify your Internet connection and register your product. If you have trouble connecting to the Internet, use the Troubleshooting Tips below to correct basic problems, or refer to the Reference Manual on the Web Safe Router Resource CD. Alternatively, you can simply open a new browser window and browse the Internet to verify Internet connectivity is active. · For each powered on computer connected to the router with a securely plugged in Ethernet cable, the corresponding router LAN port status light will be lit. The label on the bottom of the router identifies the number of each LAN port. [. . . ] Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States and/or other countries. Other brand and product names are trademarks or registered trademarks of their respective holders. [. . . ]