User manual NETGEAR KWGR614

[. . . ] 54Mbps Wireless Router Model KWGR614 Reference Manual NETGEAR, Inc. 4500 Great America Parkway Santa Clara, CA 95054 USA September 2006 © 2006 by NETGEAR, Inc. September 2006. Trademarks NETGEAR is a trademark of Netgear, Inc. Microsoft, Windows, and Windows NT are registered trademarks of Microsoft Corporation. [. . . ] They will then only accept traffic from the MAC address of that computer. This feature allows your router to masquerade as that computer by "cloning" its MAC address. The router will then capture and use the MAC address of the computer that you are now using. Click Apply to save your settings. Maintenance v1. 2, September 2006 4-3 54Mbps Wireless Router Model KWGR614 Reference Manual 5. If your Internet connection does require a login, fill in the settings according to the instructions below. Select Yes if you normally must launch a login program such as Enternet or WinPOET in order to access the Internet. Note: After you finish setting up your router, you will no longer need to launch the ISP's login program on your computer in order to access the Internet. When you start an Internet application, your router will automatically log you in. Select the protocol used by your ISP from the "Internet Service Provider" drop-down list. Figure 4-2 Note: Not all ISP protocols are listed here. The screen will change according to the ISP settings requirements of the ISP you select. Click the Test button to verify you have Internet access. 4-4 v1. 2, September 2006 Maintenance 54Mbps Wireless Router Model KWGR614 Reference Manual Viewing Wireless Router Status Information The Router Status menu provides status and usage information. From the Maintenance section of the Main Menu, click Router Status to view the Router Status screen, shown below. Figure 4-3 This screen shows the following parameters: Table 4-1. Field Account Name Firmware Version Internet Port Wireless Router Status Fields Description This field displays the Host Name assigned to the router. These parameters apply to the Internet (Wire Area Network also referred to as WAN) port of the router. Maintenance v1. 2, September 2006 4-5 54Mbps Wireless Router Model KWGR614 Reference Manual Table 4-1. Field MAC Address IP Address Wireless Router Status Fields Description This field displays the Media Access Control address being used by the Internet (WAN) port of the router. This field displays the IP address being used by the Internet (WAN) port of the router. If set to FixedIP, the router is configured to use a fixed IP address on the WAN. If set to Client, the router is configured to obtain an IP address dynamically from the ISP. This field displays the IP Subnet Mask being used by the Internet (WAN) port of the router. This field displays the Media Access Control address being used by the LAN port of the router. This field displays the IP address being used by the Local (LAN) port of the router. The default is www. routerlogin. net Identifies if the router's built-in DHCP server is active for the LAN attached devices. This field displays the IP Subnet Mask being used by the Local (LAN) port of the router. The default is 255. 255. 255. 0 These parameters apply to the Wireless port of the router. [. . . ] From the Windows run menu, type: PING -n 10 <IP address> where <IP address> is the IP address of a remote device such as your ISP's DNS server. If the path is functioning correctly, replies as in the previous section are displayed. If you do not receive replies: ­ Check that your computer has the IP address of your router listed as the default gateway. If the IP configuration of your computer is assigned by DHCP, this information will not be visible in your computer's Network Control Panel. [. . . ]